From: Rob Herring <robh@kernel.org>
To: Yong Wu <yong.wu@mediatek.com>
Cc: youlin.pei@mediatek.com, devicetree@vger.kernel.org,
Nicolas Boichat <drinkcat@chromium.org>,
srv_heupstream@mediatek.com, Joerg Roedel <joro@8bytes.org>,
Will Deacon <will.deacon@arm.com>,
linux-kernel@vger.kernel.org, Evan Green <evgreen@chromium.org>,
Tomasz Figa <tfiga@google.com>,
iommu@lists.linux-foundation.org,
Matthias Kaehlcke <mka@chromium.org>,
linux-mediatek@lists.infradead.org, yong.wu@mediatek.com,
Matthias Brugger <matthias.bgg@gmail.com>,
yingjoe.chen@mediatek.com, anan.sun@mediatek.com,
Robin Murphy <robin.murphy@arm.com>,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH v6 01/22] dt-bindings: mediatek: Add binding for mt8183 IOMMU and SMI
Date: Mon, 18 Feb 2019 09:44:45 -0600 [thread overview]
Message-ID: <20190218154445.GA28558@bogus> (raw)
In-Reply-To: <1550394300-17420-2-git-send-email-yong.wu@mediatek.com>
On Sun, 17 Feb 2019 17:04:39 +0800, Yong Wu wrote:
> This patch adds decriptions for mt8183 IOMMU and SMI.
>
> mt8183 has only one M4U like mt8173 and is also MTK IOMMU gen2 which
> uses ARM Short-Descriptor translation table format.
>
> The mt8183 M4U-SMI HW diagram is as below:
>
> EMI
> |
> M4U
> |
> ----------
> | |
> gals0-rx gals1-rx
> | |
> | |
> gals0-tx gals1-tx
> | |
> ------------
> SMI Common
> ------------
> |
> +-----+-----+--------+-----+-----+-------+-------+
> | | | | | | | |
> | | gals-rx gals-rx | gals-rx gals-rx gals-rx
> | | | | | | | |
> | | | | | | | |
> | | gals-tx gals-tx | gals-tx gals-tx gals-tx
> | | | | | | | |
> larb0 larb1 IPU0 IPU1 larb4 larb5 larb6 CCU
> disp vdec img cam venc img cam
>
> All the connections are HW fixed, SW can NOT adjust it.
>
> Compared with mt8173, we add a GALS(Global Async Local Sync) module
> between SMI-common and M4U, and additional GALS between larb2/3/5/6
> and SMI-common. GALS can help synchronize for the modules in different
> clock frequency, it can be seen as a "asynchronous fifo".
>
> GALS can only help transfer the command/data while it doesn't have
> the configuring register, thus it has the special "smi" clock and it
> doesn't have the "apb" clock. From the diagram above, we add "gals0"
> and "gals1" clocks for smi-common and add a "gals" clock for smi-larb.
>
> >From the diagram above, IPU0/IPU1(Image Processor Unit) and CCU(Camera
> Control Unit) is connected with smi-common directly, we can take them
> as "larb2", "larb3" and "larb7", and their register spaces are
> different with the normal larb.
>
> Signed-off-by: Yong Wu <yong.wu@mediatek.com>
> ---
> Hi Rob,
> In this version, I changed the picture in the binding and list the
> detailed SoCs which has "bclk" and "gals". So I don't keep your R-b.
> ---
> .../devicetree/bindings/iommu/mediatek,iommu.txt | 30 ++++-
> .../memory-controllers/mediatek,smi-common.txt | 12 +-
> .../memory-controllers/mediatek,smi-larb.txt | 4 +
> include/dt-bindings/memory/mt8183-larb-port.h | 130 +++++++++++++++++++++
> 4 files changed, 170 insertions(+), 6 deletions(-)
> create mode 100644 include/dt-bindings/memory/mt8183-larb-port.h
>
Reviewed-by: Rob Herring <robh@kernel.org>
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2019-02-18 15:45 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-17 9:04 [PATCH v6 00/22] MT8183 IOMMU SUPPORT Yong Wu
2019-02-17 9:04 ` [PATCH v6 01/22] dt-bindings: mediatek: Add binding for mt8183 IOMMU and SMI Yong Wu
2019-02-18 15:44 ` Rob Herring [this message]
2019-02-19 23:28 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 02/22] iommu/mediatek: Use a struct as the platform data Yong Wu
2019-02-17 9:04 ` [PATCH v6 03/22] memory: mtk-smi: Use a general config_port interface Yong Wu
2019-02-17 9:04 ` [PATCH v6 04/22] memory: mtk-smi: Use a struct for the platform data for smi-common Yong Wu
2019-02-17 9:04 ` [PATCH v6 05/22] iommu/io-pgtable-arm-v7s: Add paddr_to_iopte and iopte_to_paddr helpers Yong Wu
2019-02-17 9:04 ` [PATCH v6 06/22] iommu/io-pgtable-arm-v7s: Extend MediaTek 4GB Mode Yong Wu
2019-02-19 23:29 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 07/22] iommu/mediatek: Add bclk can be supported optionally Yong Wu
2019-02-17 9:04 ` [PATCH v6 08/22] iommu/mediatek: Add larb-id remapped support Yong Wu
2019-02-17 9:04 ` [PATCH v6 09/22] iommu/mediatek: Refine protect memory definition Yong Wu
2019-02-19 23:30 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 10/22] iommu/mediatek: Move reset_axi into plat_data Yong Wu
2019-02-19 23:30 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 11/22] iommu/mediatek: Move vld_pa_rng " Yong Wu
2019-02-19 23:31 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 12/22] memory: mtk-smi: Add gals support Yong Wu
2019-03-13 9:25 ` Yong Wu
2019-02-17 9:04 ` [PATCH v6 13/22] iommu/mediatek: Add mt8183 IOMMU support Yong Wu
2019-02-19 23:31 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 14/22] iommu/mediatek: Add mmu1 support Yong Wu
2019-02-17 9:04 ` [PATCH v6 15/22] memory: mtk-smi: Invoke pm runtime_callback to enable clocks Yong Wu
2019-02-17 9:04 ` [PATCH v6 16/22] memory: mtk-smi: Add bus_sel for mt8183 Yong Wu
2019-02-19 23:31 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 17/22] memory: mtk-smi: Get rid of need_larbid Yong Wu
2019-02-19 23:32 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 18/22] iommu/mediatek: Fix VLD_PA_RNG register backup when suspend Yong Wu
2019-02-17 9:04 ` [PATCH v6 19/22] iommu/mediatek: Add shutdown callback Yong Wu
2019-02-17 9:04 ` [PATCH v6 20/22] iommu/mediatek: Rename enable_4GB to dram_is_4gb Yong Wu
2019-02-19 23:32 ` Evan Green
2019-02-17 9:04 ` [PATCH v6 21/22] iommu/mediatek: Fix iova_to_phys PA start for 4GB mode Yong Wu
2019-02-19 23:33 ` Evan Green
2019-02-20 9:17 ` Yong Wu
2019-02-17 9:05 ` [PATCH v6 22/22] iommu/mediatek: Switch to SPDX license identifier Yong Wu
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190218154445.GA28558@bogus \
--to=robh@kernel.org \
--cc=anan.sun@mediatek.com \
--cc=devicetree@vger.kernel.org \
--cc=drinkcat@chromium.org \
--cc=evgreen@chromium.org \
--cc=iommu@lists.linux-foundation.org \
--cc=joro@8bytes.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=matthias.bgg@gmail.com \
--cc=mka@chromium.org \
--cc=robin.murphy@arm.com \
--cc=srv_heupstream@mediatek.com \
--cc=tfiga@google.com \
--cc=will.deacon@arm.com \
--cc=yingjoe.chen@mediatek.com \
--cc=yong.wu@mediatek.com \
--cc=youlin.pei@mediatek.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).