From: megous@megous.com
To: linux-sunxi@googlegroups.com,
Maxime Ripard <maxime.ripard@bootlin.com>,
Chen-Yu Tsai <wens@csie.org>, Rob Herring <robh+dt@kernel.org>,
Linus Walleij <linus.walleij@linaro.org>
Cc: Ondrej Jirman <megous@megous.com>,
Mark Rutland <mark.rutland@arm.com>,
David Airlie <airlied@linux.ie>,
Chi-Hsien Lin <chi-hsien.lin@cypress.com>,
dri-devel@lists.freedesktop.org,
linux-stm32@st-md-mailman.stormreply.com,
brcm80211-dev-list@cypress.com, Jose Abreu <joabreu@synopsys.com>,
Naveen Gupta <naveen.gupta@cypress.com>,
devicetree@vger.kernel.org,
Arend van Spriel <arend.vanspriel@broadcom.com>,
Alexandre Torgue <alexandre.torgue@st.com>,
Hante Meuleman <hante.meuleman@broadcom.com>,
linux-gpio@vger.kernel.org, Wright Feng <wright.feng@cypress.com>,
Giuseppe Cavallaro <peppe.cavallaro@st.com>,
linux-arm-kernel@lists.infradead.org,
Franky Lin <franky.lin@broadcom.com>,
Maxime Coquelin <mcoquelin.stm32@gmail.com>,
brcm80211-dev-list.pdl@broadcom.com, netdev@vger.kernel.org,
linux-wireless@vger.kernel.org, linux-kernel@vger.kernel.org,
Kalle Valo <kvalo@codeaurora.org>,
Daniel Vetter <daniel@ffwll.ch>,
"David S. Miller" <davem@davemloft.net>
Subject: [PATCH v3 10/11] arm64: dts: allwinner: h6: Add MMC1 pins
Date: Thu, 11 Apr 2019 12:19:50 +0200 [thread overview]
Message-ID: <20190411101951.30223-11-megous@megous.com> (raw)
In-Reply-To: <20190411101951.30223-1-megous@megous.com>
From: Ondrej Jirman <megous@megous.com>
MMC1 is used on some H6 boards we want to support. Typical use is 4-bit
SDIO interface with a WiFi chip. Add pin definitions for this use case.
As this is the only possible configration for mmc1, make it the default
one, too.
Signed-off-by: Ondrej Jirman <megous@megous.com>
---
arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi | 11 +++++++++++
1 file changed, 11 insertions(+)
diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
index e0dc4a05c1ba..bd37b849d3b7 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi
@@ -243,6 +243,15 @@
bias-pull-up;
};
+ /omit-if-no-ref/
+ mmc1_pins: mmc1-pins {
+ pins = "PG0", "PG1", "PG2", "PG3",
+ "PG4", "PG5";
+ function = "mmc1";
+ drive-strength = <30>;
+ bias-pull-up;
+ };
+
mmc2_pins: mmc2-pins {
pins = "PC1", "PC4", "PC5", "PC6",
"PC7", "PC8", "PC9", "PC10",
@@ -294,6 +303,8 @@
resets = <&ccu RST_BUS_MMC1>;
reset-names = "ahb";
interrupts = <GIC_SPI 36 IRQ_TYPE_LEVEL_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&mmc1_pins>;
status = "disabled";
#address-cells = <1>;
#size-cells = <0>;
--
2.21.0
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2019-04-11 10:21 UTC|newest]
Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-04-11 10:19 [PATCH v3 00/11] Add support for Orange Pi 3 megous
2019-04-11 10:19 ` [PATCH v3 01/11] net: stmmac: sun8i: add support for Allwinner H6 EMAC megous
2019-04-11 10:19 ` [PATCH v3 02/11] net: stmmac: sun8i: force select external PHY when no internal one megous
2019-04-11 10:19 ` [PATCH v3 03/11] pinctrl: sunxi: Prepare for alternative bias voltage setting methods megous
2019-04-11 10:34 ` [linux-sunxi] " Julian Calaby
2019-04-11 10:44 ` Ondřej Jirman
2019-04-11 10:19 ` [PATCH v3 04/11] pinctrl: sunxi: Support I/O bias voltage setting on H6 megous
2019-04-11 12:22 ` Maxime Ripard
2019-04-11 10:19 ` [PATCH v3 05/11] arm64: dts: allwinner: orange-pi-3: Enable ethernet megous
2019-04-11 10:19 ` [PATCH v3 06/11] dt-bindings: display: hdmi-connector: Add DDC power supply megous
2019-04-11 10:19 ` [PATCH v3 07/11] drm: sun4i: Add support for enabling DDC I2C bus power to dw_hdmi glue megous
2019-04-11 12:25 ` Maxime Ripard
2019-04-11 10:19 ` [PATCH v3 08/11] arm64: dts: allwinner: orange-pi-3: Enable HDMI output megous
2019-04-11 10:19 ` [PATCH v3 09/11] brcmfmac: Loading the correct firmware for brcm43456 megous
2019-04-11 10:19 ` megous [this message]
2019-04-11 10:19 ` [PATCH v3 11/11] [DO NOT MERGE] arm64: dts: allwinner: orange-pi-3: Enable WiFi megous
2019-04-12 11:05 ` [linux-sunxi] [PATCH v3 00/11] Add support for Orange Pi 3 Chen-Yu Tsai
2019-04-12 12:10 ` Ondřej Jirman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190411101951.30223-11-megous@megous.com \
--to=megous@megous.com \
--cc=airlied@linux.ie \
--cc=alexandre.torgue@st.com \
--cc=arend.vanspriel@broadcom.com \
--cc=brcm80211-dev-list.pdl@broadcom.com \
--cc=brcm80211-dev-list@cypress.com \
--cc=chi-hsien.lin@cypress.com \
--cc=daniel@ffwll.ch \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=dri-devel@lists.freedesktop.org \
--cc=franky.lin@broadcom.com \
--cc=hante.meuleman@broadcom.com \
--cc=joabreu@synopsys.com \
--cc=kvalo@codeaurora.org \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-stm32@st-md-mailman.stormreply.com \
--cc=linux-sunxi@googlegroups.com \
--cc=linux-wireless@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=maxime.ripard@bootlin.com \
--cc=mcoquelin.stm32@gmail.com \
--cc=naveen.gupta@cypress.com \
--cc=netdev@vger.kernel.org \
--cc=peppe.cavallaro@st.com \
--cc=robh+dt@kernel.org \
--cc=wens@csie.org \
--cc=wright.feng@cypress.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).