Re: [PATCH v3 0/2] Add CTS/RTS gpio support to STM32 UART

[Manivannan Sadhasivam <mani@kernel.org>]

Hi Greg,

On Mon, Apr 20, 2020 at 10:32:02PM +0530, mani@kernel.org wrote:
> From: Manivannan Sadhasivam <mani@kernel.org>
> 
> Hello,
> 
> This patchset adds CTS/RTS gpio support to STM32 UART controller.
> Eventhough the UART controller supports using dedicated CTS/RTS gpios,
> sometimes we need to use different set of gpios for flow control.
> 
> This is necessary for the upcoming STM32MP1 based board called Stinger96
> IoT-Box. On that board, a bluetooth chip is connected to one of the UART
> controller but the CTS/RTS lines got swapped mistakenly. So this patchset
> serves as a workaround for that hardware bug and also supports the
> usecase of using any gpio for CTS/RTS functionality. As per the sugggestion
> provided by Andy for v1, I've now switched to mctrl_gpio driver.
> 
> This patchset has been validated with Stinger96 IoT-Box connected to Murata
> WiFi-BT combo chip.
> 

Are you planning to take this series for 5.8?

Thanks,
Mani

> Thanks,
> Mani
> 
> Changes in v3:
> 
> * Added Andy's reviewed-by tag
> * Fixed minor issues spotted by Fabrice
> 
> Changes in v2:
> 
> As per the review by Andy:
> 
> * Switched to mctrl_gpio driver instead of using custom CTS/RTS
>   implementation
> * Removed the use of software flow control terminology.
> 
> Manivannan Sadhasivam (2):
>   dt-bindings: serial: Document CTS/RTS gpios in STM32 UART
>   tty: serial: Add modem control gpio support for STM32 UART
> 
>  .../bindings/serial/st,stm32-uart.yaml        | 14 +++++
>  drivers/tty/serial/Kconfig                    |  1 +
>  drivers/tty/serial/stm32-usart.c              | 53 ++++++++++++++++++-
>  drivers/tty/serial/stm32-usart.h              |  1 +
>  4 files changed, 67 insertions(+), 2 deletions(-)
> 
> -- 
> 2.17.1
> 

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel