[PATCH v5 08/16] thermal: sun8i: add TEMP_CALIB_MASK for calibration data in sun50i_h6_ths_calibrate

Frank Lee
2020-07-24T07:13:43Z

From: Yangtao Li <frank@allwinnertech.com>

For sun50i_h6_ths_calibrate(), the data read from nvmem needs a round of
calculation. On the other hand, the newer SOC may store other data in
the space other than 12bit sensor data. Add mask operation to read data
to avoid conversion error.

Signed-off-by: Yangtao Li <frank@allwinnertech.com>
---
drivers/thermal/sun8i_thermal.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/thermal/sun8i_thermal.c b/drivers/thermal/sun8i_thermal.c
index 74d73be16496..f423d44b9290 100644
--- a/drivers/thermal/sun8i_thermal.c
+++ b/drivers/thermal/sun8i_thermal.c
@@ -244,7 +244,7 @@ static int sun50i_h6_ths_calibrate(struct ths_device *tmdev,
ft_temp = (caldata[0] & FT_TEMP_MASK) * 100;

for (i = 0; i < tmdev->chip->sensor_num; i++) {
- int sensor_reg = caldata[i + 1];
+ int sensor_reg = caldata[i + 1] & TEMP_CALIB_MASK;
int cdata, offset;
int sensor_temp = tmdev->chip->calc_temp(tmdev, i, sensor_reg);

--
2.24.0