[PATCH 06/10] arm64: dts: ti: k3-am64: Enable PCIe nodes at the board level

From: Andrew Davis <afd@ti.com>
To: Nishanth Menon <nm@ti.com>, Vignesh Raghavendra <vigneshr@ti.com>,
	Tero Kristo <kristo@kernel.org>, Rob Herring <robh+dt@kernel.org>,
	Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
	<linux-arm-kernel@lists.infradead.org>,
	<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>
Cc: Andrew Davis <afd@ti.com>
Subject: [PATCH 06/10] arm64: dts: ti: k3-am64: Enable PCIe nodes at the board level
Date: Mon, 17 Oct 2022 14:25:28 -0500	[thread overview]
Message-ID: <20221017192532.23825-7-afd@ti.com> (raw)
In-Reply-To: <20221017192532.23825-1-afd@ti.com>

PCIe nodes defined in the top-level AM64x SoC dtsi files are incomplete
and will not be functional unless they are extended with a SerDes PHY.
And usually only one of the two modes can be used at a time as they
share a SerDes link.

As the PHY and mode is only known at the board integration level, these
nodes should only be enabled when provided with this information.

Disable the PCIe nodes in the dtsi files and only enable the ones that
are actually pinned out on a given board.

Signed-off-by: Andrew Davis <afd@ti.com>
---
 arch/arm64/boot/dts/ti/k3-am64-main.dtsi | 2 ++
 arch/arm64/boot/dts/ti/k3-am642-evm.dts  | 2 +-
 arch/arm64/boot/dts/ti/k3-am642-sk.dts   | 8 --------
 3 files changed, 3 insertions(+), 9 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-am64-main.dtsi b/arch/arm64/boot/dts/ti/k3-am64-main.dtsi
index ef1833f65bdc..b193f88a7a0f 100644
--- a/arch/arm64/boot/dts/ti/k3-am64-main.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am64-main.dtsi
@@ -871,6 +871,7 @@ pcie0_rc: pcie@f102000 {
 		ranges = <0x01000000 0x00 0x68001000  0x00 0x68001000  0x00 0x0010000>,
 			 <0x02000000 0x00 0x68011000  0x00 0x68011000  0x00 0x7fef000>;
 		dma-ranges = <0x02000000 0x0 0x0 0x0 0x0 0x00000010 0x0>;
+		status = "disabled";
 	};
 
 	pcie0_ep: pcie-ep@f102000 {
@@ -889,6 +890,7 @@ pcie0_ep: pcie-ep@f102000 {
 		clocks = <&k3_clks 114 0>;
 		clock-names = "fck";
 		max-functions = /bits/ 8 <1>;
+		status = "disabled";
 	};
 
 	epwm0: pwm@23000000 {
diff --git a/arch/arm64/boot/dts/ti/k3-am642-evm.dts b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
index 43d50ecfb211..2dec25d90240 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-evm.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-evm.dts
@@ -553,6 +553,7 @@ serdes0_pcie_link: phy@0 {
 };
 
 &pcie0_rc {
+	status = "okay";
 	reset-gpios = <&exp1 5 GPIO_ACTIVE_HIGH>;
 	phys = <&serdes0_pcie_link>;
 	phy-names = "pcie-phy";
@@ -563,7 +564,6 @@ &pcie0_ep {
 	phys = <&serdes0_pcie_link>;
 	phy-names = "pcie-phy";
 	num-lanes = <1>;
-	status = "disabled";
 };
 
 &ecap0 {
diff --git a/arch/arm64/boot/dts/ti/k3-am642-sk.dts b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
index 8b9987ccdc1b..58c71608d925 100644
--- a/arch/arm64/boot/dts/ti/k3-am642-sk.dts
+++ b/arch/arm64/boot/dts/ti/k3-am642-sk.dts
@@ -557,14 +557,6 @@ &main_r5fss1_core1 {
 			<&main_r5fss1_core1_memory_region>;
 };
 
-&pcie0_rc {
-	status = "disabled";
-};
-
-&pcie0_ep {
-	status = "disabled";
-};
-
 &ecap0 {
 	status = "okay";
 	/* PWM is available on Pin 1 of header J3 */
-- 
2.37.3


_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
