From: Mathieu Poirier <mathieu.poirier@linaro.org>
To: Peng Fan <peng.fan@nxp.com>
Cc: "Peng Fan (OSS)" <peng.fan@oss.nxp.com>,
"andersson@kernel.org" <andersson@kernel.org>,
"shawnguo@kernel.org" <shawnguo@kernel.org>,
"s.hauer@pengutronix.de" <s.hauer@pengutronix.de>,
"arnaud.pouliquen@foss.st.com" <arnaud.pouliquen@foss.st.com>,
"kernel@pengutronix.de" <kernel@pengutronix.de>,
"festevam@gmail.com" <festevam@gmail.com>,
dl-linux-imx <linux-imx@nxp.com>,
"linux-remoteproc@vger.kernel.org"
<linux-remoteproc@vger.kernel.org>,
"linux-arm-kernel@lists.infradead.org"
<linux-arm-kernel@lists.infradead.org>,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>
Subject: Re: [PATCH V2 5/6] remoteproc: imx_rproc: set Cortex-M stack/pc to TCML
Date: Mon, 13 Feb 2023 11:04:58 -0700 [thread overview]
Message-ID: <20230213180458.GB310433@p14s> (raw)
In-Reply-To: <DU0PR04MB9417620B668E43118933821388D79@DU0PR04MB9417.eurprd04.prod.outlook.com>
On Fri, Feb 03, 2023 at 12:04:27AM +0000, Peng Fan wrote:
> > Subject: Re: [PATCH V2 5/6] remoteproc: imx_rproc: set Cortex-M stack/pc
> > to TCML
> >
> > On Fri, Jan 27, 2023 at 05:22:45PM +0800, Peng Fan (OSS) wrote:
> > > From: Peng Fan <peng.fan@nxp.com>
> > >
> > > The i.MX8M Cortex-M core not has ROM. It has a requirement is the
> > > stack, pc value should be set in address 0 and 4 from the view of
> > > itself. From Cortex-A core view, the region is at TCML start address.
> > >
> > > The stack and pc value are the first two words stored in section
> > > ".interrupts" of the firmware, and the section is the first section in
> > > the firmware.
> > >
> > > When the firmware is built to run in TCML, there is no issue, because
> > > when copying elf segments, the first two words are copied to TCML also.
> > >
> > > However when the firmware is built ro run in DDR, the first two words
> > > are not copied to TCML start address.
> > >
> > > This patch is to find the ".interrupts" section, read out the first
> > > two words and write to TCML start address at offset 0 and 4.
> > >
> > > Signed-off-by: Peng Fan <peng.fan@nxp.com>
> > > ---
> > > drivers/remoteproc/imx_rproc.c | 37
> > > +++++++++++++++++++++++++++++++++-
> > > 1 file changed, 36 insertions(+), 1 deletion(-)
> > >
> > > diff --git a/drivers/remoteproc/imx_rproc.c
> > > b/drivers/remoteproc/imx_rproc.c index 295e0e0e869a..f5ee0c9bb09d
> > > 100644
> > > --- a/drivers/remoteproc/imx_rproc.c
> > > +++ b/drivers/remoteproc/imx_rproc.c
> > > @@ -7,6 +7,7 @@
> > > #include <linux/arm-smccc.h>
> > > #include <linux/clk.h>
> > > #include <linux/err.h>
> > > +#include <linux/firmware.h>
> > > #include <linux/firmware/imx/sci.h>
> > > #include <linux/interrupt.h>
> > > #include <linux/kernel.h>
> > > @@ -23,6 +24,7 @@
> > > #include <linux/workqueue.h>
> > >
> > > #include "imx_rproc.h"
> > > +#include "remoteproc_elf_helpers.h"
> > > #include "remoteproc_internal.h"
> > >
> > > #define IMX7D_SRC_SCR 0x0C
> > > @@ -634,6 +636,39 @@ static struct resource_table
> > *imx_rproc_get_loaded_rsc_table(struct rproc *rproc
> > > return (struct resource_table __force *)priv->rsc_table; }
> > >
> > > +static u64 imx_rproc_get_boot_addr(struct rproc *rproc, const struct
> > > +firmware *fw) {
> > > + struct imx_rproc *priv = rproc->priv;
> > > + const u8 *elf_data = (void *)fw->data;
> > > + u8 class = fw_elf_get_class(fw);
> > > + u64 bootaddr = rproc_elf_get_boot_addr(rproc, fw);
> > > + const void *shdr;
> > > + void __iomem *va;
> > > + u64 sh_addr, offset;
> > > +
> > > + if (priv->dcfg->devtype == IMX_RPROC_IMX8M) {
> > > + /*
> > > + * i.MX8M Cortex-M requires [stack, pc] be put in address
> > > + * [0, 4], so the da address is 0, size is 8 words.
> > > + */
> > > + va = (__force void __iomem *)rproc_da_to_va(rproc, 0, 8,
> > NULL);
> > > + shdr = rproc_elf_find_shdr(rproc, fw, ".interrupts");
> > > + if (!shdr || !va)
> > > + return bootaddr;
> > > + sh_addr = elf_shdr_get_sh_addr(class, shdr);
> >
> > This isn't used - why is it still there?
>
> will drop it.
>
> >
> > > + offset = elf_shdr_get_sh_offset(class, shdr);
> > > +
> > > + /*
> > > + * Write stack, pc to TCML start address. The TCML region
> > > + * is marked with ATT_IOMEM, so use writel.
> > > + */
> > > + writel(*(u32 *)(elf_data + offset), va);
> > > + writel(*(u32 *)(elf_data + offset + 4), va + 4);
> >
> > Here you are writing 2 words at address 0x0 and 2 words at address 0x4.
> > Why are you saying the size is 8 words in the comment above?
>
> Typo. I should mean 8 bytes.
>
How can I trust the code in this patchset when the "typo" is so obvious and
found in the comment above and 4 times in the changelog?
> Thanks,
> Peng.
>
> >
> > > + }
> > > +
> > > + return bootaddr;
> > > +}
> > > +
> > > static const struct rproc_ops imx_rproc_ops = {
> > > .prepare = imx_rproc_prepare,
> > > .attach = imx_rproc_attach,
> > > @@ -647,7 +682,7 @@ static const struct rproc_ops imx_rproc_ops = {
> > > .find_loaded_rsc_table = rproc_elf_find_loaded_rsc_table,
> > > .get_loaded_rsc_table = imx_rproc_get_loaded_rsc_table,
> > > .sanity_check = rproc_elf_sanity_check,
> > > - .get_boot_addr = rproc_elf_get_boot_addr,
> > > + .get_boot_addr = imx_rproc_get_boot_addr,
> > > };
> > >
> > > static int imx_rproc_addr_init(struct imx_rproc *priv,
> > > --
> > > 2.37.1
> > >
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2023-02-13 18:08 UTC|newest]
Thread overview: 18+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-01-27 9:22 [PATCH V2 0/6] remoteproc: imx_rproc: support firmware in DDR Peng Fan (OSS)
2023-01-27 9:22 ` [PATCH V2 1/6] remoteproc: elf_loader: introduce rproc_elf_find_shdr Peng Fan (OSS)
2023-01-27 9:22 ` [PATCH V2 2/6] remoteproc: imx_rproc: add devtype Peng Fan (OSS)
2023-02-02 21:40 ` Mathieu Poirier
2023-01-27 9:22 ` [PATCH V2 3/6] remoteproc: imx_rproc: correct i.MX8MQ DDR Code alias mapping Peng Fan (OSS)
2023-01-27 9:22 ` [PATCH V2 4/6] remoteproc: imx_rproc: force pointer type Peng Fan (OSS)
2023-01-27 9:22 ` [PATCH V2 5/6] remoteproc: imx_rproc: set Cortex-M stack/pc to TCML Peng Fan (OSS)
2023-02-02 21:56 ` Mathieu Poirier
2023-02-03 0:04 ` Peng Fan
2023-02-13 18:04 ` Mathieu Poirier [this message]
2023-02-03 12:47 ` Daniel Baluta
2023-02-03 12:50 ` Peng Fan
2023-01-27 9:22 ` [PATCH V2 6/6] remoteproc: imx_rproc: set address of .interrupts section as bootaddr Peng Fan (OSS)
2023-02-02 22:05 ` Mathieu Poirier
2023-02-03 0:12 ` Peng Fan
2023-02-03 12:49 ` [PATCH V2 0/6] remoteproc: imx_rproc: support firmware in DDR Daniel Baluta
2023-02-03 12:55 ` Peng Fan
2023-02-03 13:03 ` Daniel Baluta
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20230213180458.GB310433@p14s \
--to=mathieu.poirier@linaro.org \
--cc=andersson@kernel.org \
--cc=arnaud.pouliquen@foss.st.com \
--cc=festevam@gmail.com \
--cc=kernel@pengutronix.de \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-imx@nxp.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-remoteproc@vger.kernel.org \
--cc=peng.fan@nxp.com \
--cc=peng.fan@oss.nxp.com \
--cc=s.hauer@pengutronix.de \
--cc=shawnguo@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).