Re: [PATCH 00/12] Add TI-SCI reboot driver

From: Nishanth Menon <nm@ti.com>
To: Andrew Davis <afd@ti.com>
Cc: Tero Kristo <kristo@kernel.org>,
	Santosh Shilimkar <ssantosh@kernel.org>,
	Rob Herring <robh+dt@kernel.org>,
	Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
	Conor Dooley <conor+dt@kernel.org>,
	Sebastian Reichel <sre@kernel.org>,
	Vignesh Raghavendra <vigneshr@ti.com>,
	<linux-arm-kernel@lists.infradead.org>,
	<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
	<linux-pm@vger.kernel.org>
Subject: Re: [PATCH 00/12] Add TI-SCI reboot driver
Date: Thu, 1 Feb 2024 15:14:02 -0600	[thread overview]
Message-ID: <20240201211402.nldc6x2iosi4fkxq@morbidity> (raw)
In-Reply-To: <20240131221957.213717-1-afd@ti.com>

On 16:19-20240131, Andrew Davis wrote:
> Hello all,
> 
> While PCSI normally handles reboot for K3, this is an available
> fallback in case PCSI reboot fails. This driver is registered 
> with low priority as we want PSCI to remain the main way these
> devices are rebooted.
> 
> The important part is the binding/DT changes. Currently in
> U-Boot (which use the Linux device trees) we may not have
> PSCI available yet (pre TF-A) and so we need this node
> to correctly reboot. Adding this node in U-Boot is one of
> the last remaining deltas between the two project DT files. 
> 
> Thanks,
> Andrew
> 
> Andrew Davis (12):
>   dt-bindings: power: reset: Document ti,sci-reboot compatible
>   dt-bindings: arm: keystone: ti-sci: Add reboot-controller child node
>   power: reset: Add TI-SCI reboot driver
>   arm64: dts: ti: k3-am64: Add reboot-controller node
>   arm64: dts: ti: k3-am62: Add reboot-controller node
>   arm64: dts: ti: k3-am62a: Add reboot-controller node
>   arm64: dts: ti: k3-am62p: Add reboot-controller node
>   arm64: dts: ti: k3-am65: Add reboot-controller node
>   arm64: dts: ti: k3-j7200: Add reboot-controller node
>   arm64: dts: ti: k3-j721e: Add reboot-controller node
>   arm64: dts: ti: k3-j721s2: Add reboot-controller node
>   arm64: dts: ti: k3-j784s4: Add reboot-controller node

Maybe after the driver has been accepted, a defconfig patch(module) might be
useful?

> 
>  .../bindings/arm/keystone/ti,sci.yaml         |  8 +++
>  .../bindings/power/reset/ti,sci-reboot.yaml   | 33 ++++++++++
>  MAINTAINERS                                   |  2 +
>  arch/arm64/boot/dts/ti/k3-am62-main.dtsi      |  5 ++
>  arch/arm64/boot/dts/ti/k3-am62a-main.dtsi     |  4 ++
>  arch/arm64/boot/dts/ti/k3-am62p-main.dtsi     |  5 ++
>  arch/arm64/boot/dts/ti/k3-am64-main.dtsi      |  5 ++
>  arch/arm64/boot/dts/ti/k3-am65-wakeup.dtsi    |  4 ++
>  .../boot/dts/ti/k3-j7200-mcu-wakeup.dtsi      |  4 ++
>  .../boot/dts/ti/k3-j721e-mcu-wakeup.dtsi      |  4 ++
>  .../boot/dts/ti/k3-j721s2-mcu-wakeup.dtsi     |  4 ++
>  .../boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi     |  5 ++
>  drivers/power/reset/Kconfig                   |  7 +++
>  drivers/power/reset/Makefile                  |  1 +
>  drivers/power/reset/ti-sci-reboot.c           | 63 +++++++++++++++++++
>  15 files changed, 154 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/power/reset/ti,sci-reboot.yaml
>  create mode 100644 drivers/power/reset/ti-sci-reboot.c

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel