Re: [PATCH v2 8/8] arm64: defconfig: Enable TI eQEP Driver

From: Nishanth Menon <nm@ti.com>
To: Judith Mendez <jm@ti.com>
Cc: Rob Herring <robh@kernel.org>,
	Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>,
	Conor Dooley <conor+dt@kernel.org>,
	Catalin Marinas <catalin.marinas@arm.com>,
	Will Deacon <will@kernel.org>,
	William Breathitt Gray <william.gray@linaro.org>,
	David Lechner <david@lechnology.com>,
	<linux-arm-kernel@lists.infradead.org>,
	<devicetree@vger.kernel.org>, <linux-kernel@vger.kernel.org>,
	<linux-iio@vger.kernel.org>,
	Vignesh Raghavendra <vigneshr@ti.com>
Subject: Re: [PATCH v2 8/8] arm64: defconfig: Enable TI eQEP Driver
Date: Fri, 24 May 2024 00:59:23 -0500	[thread overview]
Message-ID: <20240524055923.zyfthiwcsbwbjg5k@undecided> (raw)
In-Reply-To: <20240523231516.545085-9-jm@ti.com>

On 18:15-20240523, Judith Mendez wrote:
> TI K3 SoC's support eQEP hardware, so enable TI eQEP driver
> to be built as a module.

All the nodes seem to be only in disabled mode, is there even a single
board that is actually using this? if so, why isn't it enabled?

> 
> Signed-off-by: Judith Mendez <jm@ti.com>
> ---
> Changes since v1:
> - No change
> ---
>  arch/arm64/configs/defconfig | 1 +
>  1 file changed, 1 insertion(+)
> 
> diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig
> index 2c30d617e1802..23d11a1b20195 100644
> --- a/arch/arm64/configs/defconfig
> +++ b/arch/arm64/configs/defconfig
> @@ -1593,6 +1593,7 @@ CONFIG_INTERCONNECT_QCOM_SM8550=y
>  CONFIG_INTERCONNECT_QCOM_SM8650=y
>  CONFIG_INTERCONNECT_QCOM_X1E80100=y
>  CONFIG_COUNTER=m
> +CONFIG_TI_EQEP=m
>  CONFIG_RZ_MTU3_CNT=m
>  CONFIG_HTE=y
>  CONFIG_HTE_TEGRA194=y
> -- 
> 2.45.1
> 

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D

_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel