Re: [PATCH v6 11/13] PCI: brcmstb: Check return value of all reset_control_xxx calls

[Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>]

On Thu, Aug 15, 2024 at 06:57:24PM -0400, Jim Quinlan wrote:
> Always check the return value for invocations of reset_control_xxx() and
> propagate the error to the next level.  Although the current functions
> in reset-brcmstb.c cannot fail, this may someday change.
> 
> Signed-off-by: Jim Quinlan <james.quinlan@broadcom.com>

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>

But one comment below.

> Reviewed-by: Stanimir Varbanov <svarbanov@suse.de>
> Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
> ---
>  drivers/pci/controller/pcie-brcmstb.c | 102 ++++++++++++++++++--------
>  1 file changed, 73 insertions(+), 29 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
> index c5d3a5e9e0fc..d19eeeed623b 100644
> --- a/drivers/pci/controller/pcie-brcmstb.c
> +++ b/drivers/pci/controller/pcie-brcmstb.c

[...]

>  static int pci_dev_may_wakeup(struct pci_dev *dev, void *data)
> @@ -1479,9 +1515,12 @@ static int brcm_pcie_suspend_noirq(struct device *dev)
>  {
>  	struct brcm_pcie *pcie = dev_get_drvdata(dev);
>  	struct pci_host_bridge *bridge = pci_host_bridge_from_priv(pcie);
> -	int ret;
> +	int ret, rret;
> +
> +	ret = brcm_pcie_turn_off(pcie);
> +	if (ret)
> +		return ret;
>  
> -	brcm_pcie_turn_off(pcie);
>  	/*
>  	 * If brcm_phy_stop() returns an error, just dev_err(). If we
>  	 * return the error it will cause the suspend to fail and this is a
> @@ -1510,7 +1549,10 @@ static int brcm_pcie_suspend_noirq(struct device *dev)
>  						     pcie->sr->supplies);
>  			if (ret) {
>  				dev_err(dev, "Could not turn off regulators\n");
> -				reset_control_reset(pcie->rescal);
> +				rret = reset_control_reset(pcie->rescal);
> +				if (rret)
> +					dev_err(dev, "failed to reset 'rascal' controller ret=%d\n",

Do you really mean to say 'rascal'? ;)

- Mani

-- 
மணிவண்ணன் சதாசிவம்