[PATCH v3 1/3] dt-bindings: display/xlnx/zynqmp-dpsub: Add audio DMAs

[Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>]

The DP subsystem for ZynqMP supports audio via two channels, and the DP
DMA has dma-engines for those channels. For some reason the DT binding
has not specified those channels, even if the picture included in
xlnx,zynqmp-dpsub.yaml shows "2 x aud" DMAs.

This hasn't caused any issues as the drivers have not supported audio,
and has thus gone unnoticed.

To make it possible to add the audio support to the driver, add the two
audio DMAs to the binding. While strictly speaking this is an ABI break,
there should be no regressions caused by this as we're adding new
entries at the end of the dmas list, and, after the audio support has
been added in "arm64: dts: zynqmp: Add DMA for DP audio",  the driver
will treat the audio DMAs as optional to also support the old bindings.

Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ideasonboard.com>
---
 .../devicetree/bindings/display/xlnx/xlnx,zynqmp-dpsub.yaml    | 10 ++++++++--
 1 file changed, 8 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/display/xlnx/xlnx,zynqmp-dpsub.yaml b/Documentation/devicetree/bindings/display/xlnx/xlnx,zynqmp-dpsub.yaml
index 554f9d5809d4..6b754d4f260e 100644
--- a/Documentation/devicetree/bindings/display/xlnx/xlnx,zynqmp-dpsub.yaml
+++ b/Documentation/devicetree/bindings/display/xlnx/xlnx,zynqmp-dpsub.yaml
@@ -100,12 +100,16 @@ properties:
       - description: Video layer, plane 1 (U/V or U)
       - description: Video layer, plane 2 (V)
       - description: Graphics layer
+      - description: Audio channel 0
+      - description: Audio channel 1
   dma-names:
     items:
       - const: vid0
       - const: vid1
       - const: vid2
       - const: gfx0
+      - const: aud0
+      - const: aud1
 
   phys:
     description: PHYs for the DP data lanes
@@ -194,11 +198,13 @@ examples:
         power-domains = <&pd_dp>;
         resets = <&reset ZYNQMP_RESET_DP>;
 
-        dma-names = "vid0", "vid1", "vid2", "gfx0";
+        dma-names = "vid0", "vid1", "vid2", "gfx0", "aud0", "aud1";
         dmas = <&xlnx_dpdma 0>,
                <&xlnx_dpdma 1>,
                <&xlnx_dpdma 2>,
-               <&xlnx_dpdma 3>;
+               <&xlnx_dpdma 3>,
+               <&xlnx_dpdma 4>,
+               <&xlnx_dpdma 5>;
 
         phys = <&psgtr 1 PHY_TYPE_DP 0 3>,
                <&psgtr 0 PHY_TYPE_DP 1 3>;

-- 
2.43.0