From: Andre Przywara <andre.przywara@arm.com>
To: Ryan Walklin <ryan@testtoast.com>
Cc: Liam Girdwood <lgirdwood@gmail.com>,
Mark Brown <broonie@kernel.org>, Jaroslav Kysela <perex@perex.cz>,
Takashi Iwai <tiwai@suse.com>, Chen-Yu Tsai <wens@csie.org>,
Jernej Skrabec <jernej.skrabec@gmail.com>,
Samuel Holland <samuel@sholland.org>,
Chris Morgan <macroalpha82@gmail.com>,
Philippe Simons <simons.philippe@gmail.com>,
linux-sound@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-sunxi@lists.linux.dev, devicetree@vger.kernel.org,
linux-clk@vger.kernel.org, Marcus Cooper <codekipper@gmail.com>
Subject: Re: [PATCH v2 4/7] ASoC: sun4i-codec: Add playback only flag to quirks
Date: Sun, 20 Oct 2024 11:37:59 +0100 [thread overview]
Message-ID: <20241020113759.1eeb76b2@minigeek.lan> (raw)
In-Reply-To: <20241020083124.174724-5-ryan@testtoast.com>
On Sun, 20 Oct 2024 21:30:54 +1300
Ryan Walklin <ryan@testtoast.com> wrote:
> From: Marcus Cooper <codekipper@gmail.com>
>
> Some devices only have the playback side of the codec implemented
> so add a quirk to check for this.
If you respin, you could mention here that the capture is also
explicitly disabled in the dai_link member in the create_card() routine
later, to keep that comment from your email alive in the commit log.
But anyway:
> Signed-off-by: Marcus Cooper <codekipper@gmail.com>
> Signed-off-by: Ryan Walklin <ryan@testtoast.com>
Reviewed-by: Andre Przywara <andre.przywara@arm.com>
Cheers,
Andre
> ---
> sound/soc/sunxi/sun4i-codec.c | 12 ++++++++----
> 1 file changed, 8 insertions(+), 4 deletions(-)
>
> diff --git a/sound/soc/sunxi/sun4i-codec.c b/sound/soc/sunxi/sun4i-codec.c
> index 37f5678b55291..312d2655c3f4e 100644
> --- a/sound/soc/sunxi/sun4i-codec.c
> +++ b/sound/soc/sunxi/sun4i-codec.c
> @@ -1571,6 +1571,7 @@ struct sun4i_codec_quirks {
> unsigned int reg_dac_txdata; /* TX FIFO offset for DMA config */
> unsigned int reg_adc_rxdata; /* RX FIFO offset for DMA config */
> bool has_reset;
> + bool playback_only;
> };
>
> static const struct sun4i_codec_quirks sun4i_codec_quirks = {
> @@ -1779,10 +1780,13 @@ static int sun4i_codec_probe(struct platform_device *pdev)
> scodec->playback_dma_data.maxburst = 8;
> scodec->playback_dma_data.addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
>
> - /* DMA configuration for RX FIFO */
> - scodec->capture_dma_data.addr = res->start + quirks->reg_adc_rxdata;
> - scodec->capture_dma_data.maxburst = 8;
> - scodec->capture_dma_data.addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
> + if (!quirks->playback_only) {
> + /* DMA configuration for RX FIFO */
> + scodec->capture_dma_data.addr = res->start +
> + quirks->reg_adc_rxdata;
> + scodec->capture_dma_data.maxburst = 8;
> + scodec->capture_dma_data.addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
> + }
>
> ret = devm_snd_soc_register_component(&pdev->dev, quirks->codec,
> &sun4i_codec_dai, 1);
next prev parent reply other threads:[~2024-10-20 10:40 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-10-20 8:30 [PATCH v2 0/7] ASoC: add Allwinner H616 audio codec support Ryan Walklin
2024-10-20 8:30 ` [PATCH v2 1/7] clk: sunxi-ng: h616: Add sigma-delta modulation settings for audio PLL Ryan Walklin
2024-10-20 11:56 ` Andre Przywara
2024-10-20 8:30 ` [PATCH v2 2/7] dt-bindings: allwinner: add H616 sun4i audio codec binding Ryan Walklin
2024-10-20 9:16 ` Rob Herring (Arm)
2024-10-20 8:30 ` [PATCH v2 3/7] ASoC: sun4i-codec: Add support for different DAC FIFOC addresses to quirks Ryan Walklin
2024-10-20 8:30 ` [PATCH v2 4/7] ASoC: sun4i-codec: Add playback only flag " Ryan Walklin
2024-10-20 10:37 ` Andre Przywara [this message]
2024-10-20 8:30 ` [PATCH v2 5/7] ASoC: sun4i-codec: support allwinner H616 codec Ryan Walklin
2024-10-20 11:59 ` Andre Przywara
2024-10-21 15:46 ` Mark Brown
2024-10-20 8:30 ` [PATCH v2 6/7] arm64: dts: allwinner: h616: Add audio codec node Ryan Walklin
2024-10-20 10:56 ` Andre Przywara
2024-10-20 8:30 ` [PATCH v2 7/7] arm64: dts: allwinner: h313/h616/h618/h700: Enable audio codec for all supported boards Ryan Walklin
2024-10-21 17:58 ` [PATCH v2 0/7] ASoC: add Allwinner H616 audio codec support Rob Herring (Arm)
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20241020113759.1eeb76b2@minigeek.lan \
--to=andre.przywara@arm.com \
--cc=broonie@kernel.org \
--cc=codekipper@gmail.com \
--cc=devicetree@vger.kernel.org \
--cc=jernej.skrabec@gmail.com \
--cc=lgirdwood@gmail.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-sound@vger.kernel.org \
--cc=linux-sunxi@lists.linux.dev \
--cc=macroalpha82@gmail.com \
--cc=perex@perex.cz \
--cc=ryan@testtoast.com \
--cc=samuel@sholland.org \
--cc=simons.philippe@gmail.com \
--cc=tiwai@suse.com \
--cc=wens@csie.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).