Re: [PATCH v3 1/2] PCI: mediatek-gen3: Add support for setting max-link-speed limit

[Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>]

On Wed, Sep 18, 2024 at 10:13:06AM +0200, AngeloGioacchino Del Regno wrote:
> Add support for respecting the max-link-speed devicetree property,
> forcing a maximum speed (Gen) for a PCI-Express port.
> 
> Since the MediaTek PCIe Gen3 controllers also expose the maximum
> supported link speed in the PCIE_BASE_CFG register, if property
> max-link-speed is specified in devicetree, validate it against the
> controller capabilities and proceed setting the limitations only
> if the wanted Gen is lower than the maximum one that is supported
> by the controller itself (otherwise it makes no sense!).
> 
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>

- Mani

> ---
>  drivers/pci/controller/pcie-mediatek-gen3.c | 55 ++++++++++++++++++++-
>  1 file changed, 53 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-mediatek-gen3.c b/drivers/pci/controller/pcie-mediatek-gen3.c
> index 66ce4b5d309b..8d4b045633da 100644
> --- a/drivers/pci/controller/pcie-mediatek-gen3.c
> +++ b/drivers/pci/controller/pcie-mediatek-gen3.c
> @@ -28,7 +28,11 @@
>  
>  #include "../pci.h"
>  
> +#define PCIE_BASE_CFG_REG		0x14
> +#define PCIE_BASE_CFG_SPEED		GENMASK(15, 8)
> +
>  #define PCIE_SETTING_REG		0x80
> +#define PCIE_SETTING_GEN_SUPPORT	GENMASK(14, 12)
>  #define PCIE_PCI_IDS_1			0x9c
>  #define PCI_CLASS(class)		(class << 8)
>  #define PCIE_RC_MODE			BIT(0)
> @@ -125,6 +129,9 @@
>  
>  struct mtk_gen3_pcie;
>  
> +#define PCIE_CONF_LINK2_CTL_STS		0x10b0
> +#define PCIE_CONF_LINK2_LCR2_LINK_SPEED	GENMASK(3, 0)
> +
>  /**
>   * struct mtk_gen3_pcie_pdata - differentiate between host generations
>   * @power_up: pcie power_up callback
> @@ -160,6 +167,7 @@ struct mtk_msi_set {
>   * @phy: PHY controller block
>   * @clks: PCIe clocks
>   * @num_clks: PCIe clocks count for this port
> + * @max_link_speed: Maximum link speed (PCIe Gen) for this port
>   * @irq: PCIe controller interrupt number
>   * @saved_irq_state: IRQ enable state saved at suspend time
>   * @irq_lock: lock protecting IRQ register access
> @@ -180,6 +188,7 @@ struct mtk_gen3_pcie {
>  	struct phy *phy;
>  	struct clk_bulk_data *clks;
>  	int num_clks;
> +	u8 max_link_speed;
>  
>  	int irq;
>  	u32 saved_irq_state;
> @@ -381,11 +390,27 @@ static int mtk_pcie_startup_port(struct mtk_gen3_pcie *pcie)
>  	int err;
>  	u32 val;
>  
> -	/* Set as RC mode */
> +	/* Set as RC mode and set controller PCIe Gen speed restriction, if any */
>  	val = readl_relaxed(pcie->base + PCIE_SETTING_REG);
>  	val |= PCIE_RC_MODE;
> +	if (pcie->max_link_speed) {
> +		val &= ~PCIE_SETTING_GEN_SUPPORT;
> +
> +		/* Can enable link speed support only from Gen2 onwards */
> +		if (pcie->max_link_speed >= 2)
> +			val |= FIELD_PREP(PCIE_SETTING_GEN_SUPPORT,
> +					  GENMASK(pcie->max_link_speed - 2, 0));
> +	}
>  	writel_relaxed(val, pcie->base + PCIE_SETTING_REG);
>  
> +	/* Set Link Control 2 (LNKCTL2) speed restriction, if any */
> +	if (pcie->max_link_speed) {
> +		val = readl_relaxed(pcie->base + PCIE_CONF_LINK2_CTL_STS);
> +		val &= ~PCIE_CONF_LINK2_LCR2_LINK_SPEED;
> +		val |= FIELD_PREP(PCIE_CONF_LINK2_LCR2_LINK_SPEED, pcie->max_link_speed);
> +		writel_relaxed(val, pcie->base + PCIE_CONF_LINK2_CTL_STS);
> +	}
> +
>  	/* Set class code */
>  	val = readl_relaxed(pcie->base + PCIE_PCI_IDS_1);
>  	val &= ~GENMASK(31, 8);
> @@ -1004,9 +1029,21 @@ static void mtk_pcie_power_down(struct mtk_gen3_pcie *pcie)
>  	reset_control_bulk_assert(pcie->soc->phy_resets.num_resets, pcie->phy_resets);
>  }
>  
> +static int mtk_pcie_get_controller_max_link_speed(struct mtk_gen3_pcie *pcie)
> +{
> +	u32 val;
> +	int ret;
> +
> +	val = readl_relaxed(pcie->base + PCIE_BASE_CFG_REG);
> +	val = FIELD_GET(PCIE_BASE_CFG_SPEED, val);
> +	ret = fls(val);
> +
> +	return ret > 0 ? ret : -EINVAL;
> +}
> +
>  static int mtk_pcie_setup(struct mtk_gen3_pcie *pcie)
>  {
> -	int err;
> +	int err, max_speed;
>  
>  	err = mtk_pcie_parse_port(pcie);
>  	if (err)
> @@ -1031,6 +1068,20 @@ static int mtk_pcie_setup(struct mtk_gen3_pcie *pcie)
>  	if (err)
>  		return err;
>  
> +	err = of_pci_get_max_link_speed(pcie->dev->of_node);
> +	if (err > 0) {
> +		/* Get the maximum speed supported by the controller */
> +		max_speed = mtk_pcie_get_controller_max_link_speed(pcie);
> +
> +		/* Set max_link_speed only if the controller supports it */
> +		if (max_speed >= 0 && max_speed <= err) {
> +			pcie->max_link_speed = err;
> +			dev_dbg(pcie->dev,
> +				"Max controller link speed Gen%d, override to Gen%u",
> +				max_speed, pcie->max_link_speed);
> +		}
> +	}
> +
>  	/* Try link up */
>  	err = mtk_pcie_startup_port(pcie);
>  	if (err)
> -- 
> 2.46.0
> 
> 

-- 
மணிவண்ணன் சதாசிவம்