[PATCH v5 0/4] Add support for NetCube Systems Kumquat

[Lukas Schmid <lukas.schmid@netcube.li>]

This series adds dt-bindings and dt's for the NetCube Systems Kumquat
board.

Changes in v2:
  Fix the devicetrees according to the 
    "dt-schema" and "make dtbs_check W=1"
  Fix the License of the devicetree as requested
  Create a cover letter for the patch series

Changes in v3:
  Disable rtc inside the SoC again, as the rtc does not work on the
    board
  Add the gpio-reserved-ranges property to the pinctrl bindings
  Reorder the nodes in the devicetree to match the order of the nodes 
    in the sun8i-v3s.dtsi file

Changes in v4:
  Moved the dtsi change into a sperate patch
  Update commit messages to include better descriptions
  Add descriptions to the uarts and mmc nodes in the dts file
  Add missing newline at the end of the dts file
  Removed the gpio-reserved-ranges property from the dts and
    from the pinctrl bindings
  Remove the rtc status property from the dts file

Changes in v5:
  Remove the unused lradc node and it's regualtor, as they
    are not used on the board
  Add another alias for the SoC's rtc as 'rtc1'

Signed-off-by: Lukas Schmid <lukas.schmid@netcube.li>
---
Lukas Schmid (4):
  dt-bindings: vendor-prefixes: Add NetCube Systems Austria name
  dt-bindings: arm: sunxi: Add NetCube Systems Kumquat board
  ARM: dts: sunxi: add uart1_pe pinctrl for sun8i-v3s
  ARM: dts: sunxi: add support for NetCube Systems Kumquat

 .../devicetree/bindings/arm/sunxi.yaml        |   5 +
 .../devicetree/bindings/vendor-prefixes.yaml  |   2 +
 arch/arm/boot/dts/allwinner/Makefile          |   2 +
 .../allwinner/sun8i-v3s-netcube-kumquat.dts   | 274 ++++++++++++++++++
 arch/arm/boot/dts/allwinner/sun8i-v3s.dtsi    |   6 +
 5 files changed, 289 insertions(+)
 create mode 100644 arch/arm/boot/dts/allwinner/sun8i-v3s-netcube-kumquat.dts

-- 
2.47.1