[PATCH v2] irqchip/sunxi-nmi: add missing flag

[Philippe Simons <simons.philippe@gmail.com>]

Some boards with Allwinner SoCs connect the PMIC's IRQ pin to the SoC's
NMI pin instead of a normal GPIO. Since the power key is connected
to the PMIC, and people expect to wake up a suspended system via
this key, the NMI IRQ controller must stay alive when the
system goes into suspend.

Add the flag to prevent the sunxi NMI controller from going to sleep,
so that the power key can wake up those systems.

Signed-off-by: Philippe Simons <simons.philippe@gmail.com>
---
 drivers/irqchip/irq-sunxi-nmi.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/irqchip/irq-sunxi-nmi.c b/drivers/irqchip/irq-sunxi-nmi.c
index bb92fd85e..8dda0a85e 100644
--- a/drivers/irqchip/irq-sunxi-nmi.c
+++ b/drivers/irqchip/irq-sunxi-nmi.c
@@ -186,7 +186,9 @@ static int __init sunxi_sc_nmi_irq_init(struct device_node *node,
 	gc->chip_types[0].chip.irq_unmask	= irq_gc_mask_set_bit;
 	gc->chip_types[0].chip.irq_eoi		= irq_gc_ack_set_bit;
 	gc->chip_types[0].chip.irq_set_type	= sunxi_sc_nmi_set_type;
-	gc->chip_types[0].chip.flags		= IRQCHIP_EOI_THREADED | IRQCHIP_EOI_IF_HANDLED;
+	gc->chip_types[0].chip.flags		= IRQCHIP_EOI_THREADED |
+											IRQCHIP_EOI_IF_HANDLED |
+											IRQCHIP_SKIP_SET_WAKE;
 	gc->chip_types[0].regs.ack		= reg_offs->pend;
 	gc->chip_types[0].regs.mask		= reg_offs->enable;
 	gc->chip_types[0].regs.type		= reg_offs->ctrl;
-- 
2.47.1