From: Jacky Bai <ping.bai@nxp.com>
To: rafael@kernel.org, daniel.lezcano@linaro.org,
lpieralisi@kernel.org, sudeep.holla@arm.com,
ulf.hansson@linaro.org, james.morse@arm.com, d-gole@ti.com,
anup@brainfault.org, paul.walmsley@sifive.com,
palmer@dabbelt.com, aou@eecs.berkeley.edu
Cc: linux-pm@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
linux-kernel@vger.kernel.org, linux-riscv@lists.infradead.org,
imx@lists.linux.dev, khilman@baylibre.com,
quic_tingweiz@quicinc.com, quic_yuanjiey@quicinc.com
Subject: [PATCH v4] cpuidle: Init cpuidle only for present CPUs
Date: Fri, 7 Mar 2025 16:03:03 +0800 [thread overview]
Message-ID: <20250307080303.2660506-1-ping.bai@nxp.com> (raw)
for_each_possible_cpu() is currently used to initialize cpuidle
in below cpuidle drivers:
drivers/cpuidle/cpuidle-arm.c
drivers/cpuidle/cpuidle-big_little.c
drivers/cpuidle/cpuidle-psci.c
drivers/cpuidle/cpuidle-riscv-sbi.c
However, in cpu_dev_register_generic(), for_each_present_cpu()
is used to register CPU devices which means the CPU devices are
only registered for present CPUs and not all possible CPUs.
With nosmp or maxcpus=0, only the boot CPU is present, lead
to the failure:
| Failed to register cpuidle device for cpu1
Then rollback to cancel all CPUs' cpuidle registration.
Change for_each_possible_cpu() to for_each_present_cpu() in the
above cpuidle drivers to ensure it only registers cpuidle devices
for CPUs that are actually present.
Fixes: b0c69e1214bc ("drivers: base: Use present CPUs in GENERIC_CPU_DEVICES")
Reviewed-by: Dhruva Gole <d-gole@ti.com>
Reviewed-by: Sudeep Holla <sudeep.holla@arm.com>
Tested-by: Yuanjie Yang <quic_yuanjiey@quicinc.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
---
- v4 changes:
- add changes for other cpuidle driver that has the similar issue
as cpuidle-pcsi driver.
- v3 changes:
- improve the changelog as suggested by Sudeep
---
drivers/cpuidle/cpuidle-arm.c | 8 ++++----
drivers/cpuidle/cpuidle-big_little.c | 2 +-
drivers/cpuidle/cpuidle-psci.c | 4 ++--
drivers/cpuidle/cpuidle-riscv-sbi.c | 4 ++--
4 files changed, 9 insertions(+), 9 deletions(-)
diff --git a/drivers/cpuidle/cpuidle-arm.c b/drivers/cpuidle/cpuidle-arm.c
index caba6f4bb1b7..e044fefdb816 100644
--- a/drivers/cpuidle/cpuidle-arm.c
+++ b/drivers/cpuidle/cpuidle-arm.c
@@ -137,9 +137,9 @@ static int __init arm_idle_init_cpu(int cpu)
/*
* arm_idle_init - Initializes arm cpuidle driver
*
- * Initializes arm cpuidle driver for all CPUs, if any CPU fails
- * to register cpuidle driver then rollback to cancel all CPUs
- * registration.
+ * Initializes arm cpuidle driver for all present CPUs, if any
+ * CPU fails to register cpuidle driver then rollback to cancel
+ * all CPUs registration.
*/
static int __init arm_idle_init(void)
{
@@ -147,7 +147,7 @@ static int __init arm_idle_init(void)
struct cpuidle_driver *drv;
struct cpuidle_device *dev;
- for_each_possible_cpu(cpu) {
+ for_each_present_cpu(cpu) {
ret = arm_idle_init_cpu(cpu);
if (ret)
goto out_fail;
diff --git a/drivers/cpuidle/cpuidle-big_little.c b/drivers/cpuidle/cpuidle-big_little.c
index 74972deda0ea..4abba42fcc31 100644
--- a/drivers/cpuidle/cpuidle-big_little.c
+++ b/drivers/cpuidle/cpuidle-big_little.c
@@ -148,7 +148,7 @@ static int __init bl_idle_driver_init(struct cpuidle_driver *drv, int part_id)
if (!cpumask)
return -ENOMEM;
- for_each_possible_cpu(cpu)
+ for_each_present_cpu(cpu)
if (smp_cpuid_part(cpu) == part_id)
cpumask_set_cpu(cpu, cpumask);
diff --git a/drivers/cpuidle/cpuidle-psci.c b/drivers/cpuidle/cpuidle-psci.c
index dd8d776d6e39..b46a83f5ffe4 100644
--- a/drivers/cpuidle/cpuidle-psci.c
+++ b/drivers/cpuidle/cpuidle-psci.c
@@ -403,7 +403,7 @@ static int psci_idle_init_cpu(struct device *dev, int cpu)
/*
* psci_idle_probe - Initializes PSCI cpuidle driver
*
- * Initializes PSCI cpuidle driver for all CPUs, if any CPU fails
+ * Initializes PSCI cpuidle driver for all present CPUs, if any CPU fails
* to register cpuidle driver then rollback to cancel all CPUs
* registration.
*/
@@ -413,7 +413,7 @@ static int psci_cpuidle_probe(struct platform_device *pdev)
struct cpuidle_driver *drv;
struct cpuidle_device *dev;
- for_each_possible_cpu(cpu) {
+ for_each_present_cpu(cpu) {
ret = psci_idle_init_cpu(&pdev->dev, cpu);
if (ret)
goto out_fail;
diff --git a/drivers/cpuidle/cpuidle-riscv-sbi.c b/drivers/cpuidle/cpuidle-riscv-sbi.c
index 0c92a628bbd4..0fe1ece9fbdc 100644
--- a/drivers/cpuidle/cpuidle-riscv-sbi.c
+++ b/drivers/cpuidle/cpuidle-riscv-sbi.c
@@ -529,8 +529,8 @@ static int sbi_cpuidle_probe(struct platform_device *pdev)
return ret;
}
- /* Initialize CPU idle driver for each CPU */
- for_each_possible_cpu(cpu) {
+ /* Initialize CPU idle driver for each present CPU */
+ for_each_present_cpu(cpu) {
ret = sbi_cpuidle_init_cpu(&pdev->dev, cpu);
if (ret) {
pr_debug("HART%ld: idle driver init failed\n",
--
2.34.1
next reply other threads:[~2025-03-07 8:05 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-03-07 8:03 Jacky Bai [this message]
2025-03-07 9:50 ` [PATCH v4] cpuidle: Init cpuidle only for present CPUs Sudeep Holla
2025-03-07 10:02 ` Jacky Bai
2025-03-07 10:04 ` Sudeep Holla
2025-03-07 10:10 ` Jacky Bai
2025-03-07 10:19 ` Sudeep Holla
2025-03-07 10:26 ` Jacky Bai
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20250307080303.2660506-1-ping.bai@nxp.com \
--to=ping.bai@nxp.com \
--cc=anup@brainfault.org \
--cc=aou@eecs.berkeley.edu \
--cc=d-gole@ti.com \
--cc=daniel.lezcano@linaro.org \
--cc=imx@lists.linux.dev \
--cc=james.morse@arm.com \
--cc=khilman@baylibre.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=linux-riscv@lists.infradead.org \
--cc=lpieralisi@kernel.org \
--cc=palmer@dabbelt.com \
--cc=paul.walmsley@sifive.com \
--cc=quic_tingweiz@quicinc.com \
--cc=quic_yuanjiey@quicinc.com \
--cc=rafael@kernel.org \
--cc=sudeep.holla@arm.com \
--cc=ulf.hansson@linaro.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox