From: Krzysztof Kozlowski <krzk@kernel.org>
To: Maud Spierings | GOcontroll <maudspierings@gocontroll.com>
Cc: Rob Herring <robh@kernel.org>,
Neil Armstrong <neil.armstrong@linaro.org>,
Jessica Zhang <quic_jesszhan@quicinc.com>,
Maarten Lankhorst <maarten.lankhorst@linux.intel.com>,
Maxime Ripard <mripard@kernel.org>,
Thomas Zimmermann <tzimmermann@suse.de>,
David Airlie <airlied@gmail.com>,
Simona Vetter <simona@ffwll.ch>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Thierry Reding <thierry.reding@gmail.com>,
Sam Ravnborg <sam@ravnborg.org>, Liu Ying <victor.liu@nxp.com>,
Shawn Guo <shawnguo@kernel.org>,
Sascha Hauer <s.hauer@pengutronix.de>,
Pengutronix Kernel Team <kernel@pengutronix.de>,
Fabio Estevam <festevam@gmail.com>,
Mark Brown <broonie@kernel.org>,
"dri-devel@lists.freedesktop.org"
<dri-devel@lists.freedesktop.org>,
"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
"imx@lists.linux.dev" <imx@lists.linux.dev>,
"linux-arm-kernel@lists.infradead.org"
<linux-arm-kernel@lists.infradead.org>,
"linux-spi@vger.kernel.org" <linux-spi@vger.kernel.org>
Subject: Re: [PATCH v2 03/12] dt-bindings: connector: Add the GOcontroll Moduline module slot bindings
Date: Mon, 17 Mar 2025 11:34:48 +0100 [thread overview]
Message-ID: <20250317-massive-calm-bat-43ff61@krzk-bin> (raw)
In-Reply-To: <PA4PR04MB7630094413C8E1F3D715EE23C5DD2@PA4PR04MB7630.eurprd04.prod.outlook.com>
On Sat, Mar 15, 2025 at 07:32:28AM +0000, Maud Spierings | GOcontroll wrote:
> >> +required:
> >> + - compatible
> >> + - reg
> >> + - reset-gpios
> >> + - interrupts
> >> + - sync-gpios
> >> + - i2c-bus
> >> + - slot-number
> >> +
> >> +additionalProperties: false
> >> +
> >> +examples:
> >> + - |
> >> + #include <dt-bindings/gpio/gpio.h>
> >> + #include <dt-bindings/interrupt-controller/irq.h>
> >> +
> >> + spi {
> >> + #address-cells = <1>;
> >> + #size-cells = <0>;
> >> +
> >> + connector@0 {
> >
> >I find this being a SPI device a bit strange. Is there a defined SPI
> >device that every slot is going to have? Or the connector has SPI
> >interface and *anything* could be attached on it?
>
> So a module slot is like a pcie slot, it can be occupied or not, and when
But which buses...
Best regards,
Krzysztof
next prev parent reply other threads:[~2025-03-17 10:46 UTC|newest]
Thread overview: 22+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-02-26 14:19 [PATCH v2 00/12] arm64: dts: freescale: Add support for the GOcontroll Moduline Display Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 01/12] dt-bindings: arm: fsl: Add " Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 02/12] dt-bindings: vendor-prefixes: add GOcontroll Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 03/12] dt-bindings: connector: Add the GOcontroll Moduline module slot bindings Maud Spierings via B4 Relay
2025-03-14 21:06 ` Rob Herring
2025-03-15 7:33 ` Maud Spierings | GOcontroll
[not found] ` <PA4PR04MB7630094413C8E1F3D715EE23C5DD2@PA4PR04MB7630.eurprd04.prod.outlook.com>
2025-03-17 10:34 ` Krzysztof Kozlowski [this message]
2025-03-17 10:42 ` Maud Spierings | GOcontroll
2025-03-18 15:37 ` Rob Herring
2025-03-18 16:03 ` Maud Spierings | GOcontroll
2025-02-26 14:19 ` [PATCH v2 04/12] arm64: dts: imx8mp: Add pinctrl config definitions Maud Spierings via B4 Relay
2025-02-26 15:32 ` Daniel Baluta
2025-02-26 14:19 ` [PATCH v2 05/12] MAINTAINERS: add maintainer for the Ka-Ro tx8p-ml81 COM module Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 06/12] MAINTAINERS: add maintainer for the GOcontroll Moduline module slot Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 07/12] MAINTAINERS: add maintainer for the GOcontroll Moduline controllers Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 08/12] arm64: dts: freescale: add Ka-Ro Electronics tx8p-ml81 COM Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 09/12] arm64: dts: freescale: Add the GOcontroll Moduline Display baseboard Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 10/12] arm64: dts: freescale: Add the BOE av101hdt-a10 variant of the Moduline Display Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 11/12] arm64: dts: freescale: Add the BOE av123z7m-n17 " Maud Spierings via B4 Relay
2025-02-26 14:19 ` [PATCH v2 12/12] spi: spidev: Add an entry for the gocontroll moduline module slot Maud Spierings via B4 Relay
2025-02-26 22:27 ` [PATCH v2 00/12] arm64: dts: freescale: Add support for the GOcontroll Moduline Display Rob Herring (Arm)
2025-03-14 15:53 ` (subset) " Mark Brown
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20250317-massive-calm-bat-43ff61@krzk-bin \
--to=krzk@kernel.org \
--cc=airlied@gmail.com \
--cc=broonie@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=dri-devel@lists.freedesktop.org \
--cc=festevam@gmail.com \
--cc=imx@lists.linux.dev \
--cc=kernel@pengutronix.de \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-spi@vger.kernel.org \
--cc=maarten.lankhorst@linux.intel.com \
--cc=maudspierings@gocontroll.com \
--cc=mripard@kernel.org \
--cc=neil.armstrong@linaro.org \
--cc=quic_jesszhan@quicinc.com \
--cc=robh@kernel.org \
--cc=s.hauer@pengutronix.de \
--cc=sam@ravnborg.org \
--cc=shawnguo@kernel.org \
--cc=simona@ffwll.ch \
--cc=thierry.reding@gmail.com \
--cc=tzimmermann@suse.de \
--cc=victor.liu@nxp.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).