[net-next PATCH v2 2/2] net: phy: mediatek: add Airoha PHY ID to SoC driver

[Christian Marangi <ansuelsmth@gmail.com>]

Airoha AN7581 SoC ship with a Switch based on the MT753x Switch embedded
in other SoC like the MT7581 and the MT7988. Similar to these they
require configuring some pin to enable LED PHYs.

Add support for the PHY ID for the Airoha embedded Switch and define a
simple probe function to toggle these pins. Also fill the LED functions
and add dedicated function to define LED polarity.

Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Christian Marangi <ansuelsmth@gmail.com>
---
Changes v2:
- Add Reviewed-by tag
- Address suggested dependency from Russell

 drivers/net/phy/mediatek/Kconfig      |  4 +-
 drivers/net/phy/mediatek/mtk-ge-soc.c | 62 +++++++++++++++++++++++++++
 2 files changed, 65 insertions(+), 1 deletion(-)

diff --git a/drivers/net/phy/mediatek/Kconfig b/drivers/net/phy/mediatek/Kconfig
index 6a4c2b328c41..4308002bb82c 100644
--- a/drivers/net/phy/mediatek/Kconfig
+++ b/drivers/net/phy/mediatek/Kconfig
@@ -15,7 +15,9 @@ config MEDIATEK_GE_PHY
 
 config MEDIATEK_GE_SOC_PHY
 	tristate "MediaTek SoC Ethernet PHYs"
-	depends on (ARM64 && ARCH_MEDIATEK && NVMEM_MTK_EFUSE) || COMPILE_TEST
+	depends on ARM64 || COMPILE_TEST
+	depends on ARCH_AIROHA || (ARCH_MEDIATEK && NVMEM_MTK_EFUSE) || \
+		   COMPILE_TEST
 	select MTK_NET_PHYLIB
 	help
 	  Supports MediaTek SoC built-in Gigabit Ethernet PHYs.
diff --git a/drivers/net/phy/mediatek/mtk-ge-soc.c b/drivers/net/phy/mediatek/mtk-ge-soc.c
index 175cf5239bba..fd0e447ffce7 100644
--- a/drivers/net/phy/mediatek/mtk-ge-soc.c
+++ b/drivers/net/phy/mediatek/mtk-ge-soc.c
@@ -11,8 +11,11 @@
 #include "../phylib.h"
 #include "mtk.h"
 
+#define MTK_PHY_MAX_LEDS			2
+
 #define MTK_GPHY_ID_MT7981			0x03a29461
 #define MTK_GPHY_ID_MT7988			0x03a29481
+#define MTK_GPHY_ID_AN7581			0x03a294c1
 
 #define MTK_EXT_PAGE_ACCESS			0x1f
 #define MTK_PHY_PAGE_STANDARD			0x0000
@@ -1406,6 +1409,53 @@ static int mt7981_phy_probe(struct phy_device *phydev)
 	return mt798x_phy_calibration(phydev);
 }
 
+static int an7581_phy_probe(struct phy_device *phydev)
+{
+	struct mtk_socphy_priv *priv;
+	struct pinctrl *pinctrl;
+
+	/* Toggle pinctrl to enable PHY LED */
+	pinctrl = devm_pinctrl_get_select(&phydev->mdio.dev, "gbe-led");
+	if (IS_ERR(pinctrl))
+		dev_err(&phydev->mdio.bus->dev,
+			"Failed to setup PHY LED pinctrl\n");
+
+	priv = devm_kzalloc(&phydev->mdio.dev, sizeof(*priv), GFP_KERNEL);
+	if (!priv)
+		return -ENOMEM;
+
+	phydev->priv = priv;
+
+	return 0;
+}
+
+static int an7581_phy_led_polarity_set(struct phy_device *phydev, int index,
+				       unsigned long modes)
+{
+	u32 mode;
+	u16 val;
+
+	if (index >= MTK_PHY_MAX_LEDS)
+		return -EINVAL;
+
+	for_each_set_bit(mode, &modes, __PHY_LED_MODES_NUM) {
+		switch (mode) {
+		case PHY_LED_ACTIVE_LOW:
+			val = MTK_PHY_LED_ON_POLARITY;
+			break;
+		case PHY_LED_ACTIVE_HIGH:
+			val = 0;
+			break;
+		default:
+			return -EINVAL;
+		}
+	}
+
+	return phy_modify_mmd(phydev, MDIO_MMD_VEND2, index ?
+			      MTK_PHY_LED1_ON_CTRL : MTK_PHY_LED0_ON_CTRL,
+			      MTK_PHY_LED_ON_POLARITY, val);
+}
+
 static struct phy_driver mtk_socphy_driver[] = {
 	{
 		PHY_ID_MATCH_EXACT(MTK_GPHY_ID_MT7981),
@@ -1441,6 +1491,17 @@ static struct phy_driver mtk_socphy_driver[] = {
 		.led_hw_control_set = mt798x_phy_led_hw_control_set,
 		.led_hw_control_get = mt798x_phy_led_hw_control_get,
 	},
+	{
+		PHY_ID_MATCH_EXACT(MTK_GPHY_ID_AN7581),
+		.name		= "Airoha AN7581 PHY",
+		.probe		= an7581_phy_probe,
+		.led_blink_set	= mt798x_phy_led_blink_set,
+		.led_brightness_set = mt798x_phy_led_brightness_set,
+		.led_hw_is_supported = mt798x_phy_led_hw_is_supported,
+		.led_hw_control_set = mt798x_phy_led_hw_control_set,
+		.led_hw_control_get = mt798x_phy_led_hw_control_get,
+		.led_polarity_set = an7581_phy_led_polarity_set,
+	},
 };
 
 module_phy_driver(mtk_socphy_driver);
@@ -1448,6 +1509,7 @@ module_phy_driver(mtk_socphy_driver);
 static const struct mdio_device_id __maybe_unused mtk_socphy_tbl[] = {
 	{ PHY_ID_MATCH_EXACT(MTK_GPHY_ID_MT7981) },
 	{ PHY_ID_MATCH_EXACT(MTK_GPHY_ID_MT7988) },
+	{ PHY_ID_MATCH_EXACT(MTK_GPHY_ID_AN7581) },
 	{ }
 };
 
-- 
2.48.1