From: Yunfei Dong <yunfei.dong@mediatek.com>
To: "Nícolas F . R . A . Prado" <nfraprado@collabora.com>,
"Sebastian Fricke" <sebastian.fricke@collabora.com>,
"Nicolas Dufresne" <nicolas.dufresne@collabora.com>,
"Hans Verkuil" <hverkuil-cisco@xs4all.nl>,
"AngeloGioacchino Del Regno"
<angelogioacchino.delregno@collabora.com>,
"Benjamin Gaignard" <benjamin.gaignard@collabora.com>,
"Nathan Hebert" <nhebert@chromium.org>,
"Daniel Almeida" <daniel.almeida@collabora.com>
Cc: Hsin-Yi Wang <hsinyi@chromium.org>,
Fritz Koenig <frkoenig@chromium.org>,
Daniel Vetter <daniel@ffwll.ch>,
Steve Cho <stevecho@chromium.org>,
Yunfei Dong <yunfei.dong@mediatek.com>,
<linux-media@vger.kernel.org>, <devicetree@vger.kernel.org>,
<linux-kernel@vger.kernel.org>,
<linux-arm-kernel@lists.infradead.org>,
<linux-mediatek@lists.infradead.org>,
<Project_Global_Chrome_Upstream_Group@mediatek.com>
Subject: [PATCH 14/14] media: mediatek: decoder: support av1 extend vsi
Date: Sat, 10 May 2025 15:53:44 +0800 [thread overview]
Message-ID: <20250510075357.11761-15-yunfei.dong@mediatek.com> (raw)
In-Reply-To: <20250510075357.11761-1-yunfei.dong@mediatek.com>
The driver can't access tile buffer address for extend architecture,
set tile group information in vcp and share it with kernel.
Signed-off-by: Yunfei Dong <yunfei.dong@mediatek.com>
---
.../vcodec/decoder/vdec/vdec_av1_req_lat_if.c | 46 ++++++++++++++++---
1 file changed, 39 insertions(+), 7 deletions(-)
diff --git a/drivers/media/platform/mediatek/vcodec/decoder/vdec/vdec_av1_req_lat_if.c b/drivers/media/platform/mediatek/vcodec/decoder/vdec/vdec_av1_req_lat_if.c
index 6070485e26c4..43541faeea87 100644
--- a/drivers/media/platform/mediatek/vcodec/decoder/vdec/vdec_av1_req_lat_if.c
+++ b/drivers/media/platform/mediatek/vcodec/decoder/vdec/vdec_av1_req_lat_if.c
@@ -25,6 +25,8 @@
#define AV1_INVALID_IDX -1
+#define AV1_NON_EXT_VSI_SIZE 0xD50
+
#define AV1_DIV_ROUND_UP_POW2(value, n) \
({ \
typeof(n) _n = n; \
@@ -641,6 +643,8 @@ struct vdec_av1_slice_fb {
* @frame: current frame info
* @state: status after decode done
* @cur_lst_tile_id: tile id for large scale
+ * @tile_group: tile group info
+ * @reserved: reserved
*/
struct vdec_av1_slice_vsi {
/* lat */
@@ -665,6 +669,8 @@ struct vdec_av1_slice_vsi {
struct vdec_av1_slice_frame frame;
struct vdec_av1_slice_state state;
u32 cur_lst_tile_id;
+ struct vdec_av1_slice_tile_group tile_group;
+ unsigned int reserved[4];
};
/**
@@ -1394,13 +1400,18 @@ static int vdec_av1_slice_setup_tile_group(struct vdec_av1_slice_instance *insta
struct vdec_av1_slice_vsi *vsi)
{
struct v4l2_ctrl_av1_tile_group_entry *ctrl_tge;
- struct vdec_av1_slice_tile_group *tile_group = &instance->tile_group;
+ struct vdec_av1_slice_tile_group *tile_group;
struct vdec_av1_slice_uncompressed_header *uh = &vsi->frame.uh;
struct vdec_av1_slice_tile *tile = &uh->tile;
struct v4l2_ctrl *ctrl;
u32 tge_size;
int i;
+ if (IS_VDEC_SUPPORT_EXT(instance->ctx->dev->dec_capability))
+ tile_group = &vsi->tile_group;
+ else
+ tile_group = &instance->tile_group;
+
ctrl = v4l2_ctrl_find(&instance->ctx->ctrl_hdl, V4L2_CID_STATELESS_AV1_TILE_GROUP_ENTRY);
if (!ctrl)
return -EINVAL;
@@ -1601,6 +1612,7 @@ static void vdec_av1_slice_setup_lat_buffer(struct vdec_av1_slice_instance *inst
struct vdec_lat_buf *lat_buf)
{
struct vdec_av1_slice_work_buffer *work_buffer;
+ u32 num_tiles;
int i;
vsi->bs.dma_addr = bs->dma_addr;
@@ -1635,12 +1647,18 @@ static void vdec_av1_slice_setup_lat_buffer(struct vdec_av1_slice_instance *inst
vsi->tile.buf = instance->tile.dma_addr;
vsi->tile.size = instance->tile.size;
- memcpy(lat_buf->tile_addr.va, instance->tile.va, 64 * instance->tile_group.num_tiles);
vsi->cdf_table.buf = instance->cdf_table.dma_addr;
vsi->cdf_table.size = instance->cdf_table.size;
vsi->iq_table.buf = instance->iq_table.dma_addr;
vsi->iq_table.size = instance->iq_table.size;
+
+ if (IS_VDEC_SUPPORT_EXT(instance->ctx->dev->dec_capability))
+ num_tiles = vsi->tile_group.num_tiles;
+ else
+ num_tiles = instance->tile_group.num_tiles;
+
+ memcpy(lat_buf->tile_addr.va, instance->tile.va, 64 * num_tiles);
}
static void vdec_av1_slice_setup_seg_buffer(struct vdec_av1_slice_instance *instance,
@@ -1663,7 +1681,7 @@ static void vdec_av1_slice_setup_tile_buffer(struct vdec_av1_slice_instance *ins
struct vdec_av1_slice_vsi *vsi,
struct mtk_vcodec_mem *bs)
{
- struct vdec_av1_slice_tile_group *tile_group = &instance->tile_group;
+ struct vdec_av1_slice_tile_group *tile_group;
struct vdec_av1_slice_uncompressed_header *uh = &vsi->frame.uh;
struct vdec_av1_slice_tile *tile = &uh->tile;
u32 tile_num, tile_row, tile_col;
@@ -1674,6 +1692,11 @@ static void vdec_av1_slice_setup_tile_buffer(struct vdec_av1_slice_instance *ins
u32 *tile_info_buf = instance->tile.va;
u64 pa = (u64)bs->dma_addr;
+ if (IS_VDEC_SUPPORT_EXT(instance->ctx->dev->dec_capability))
+ tile_group = &vsi->tile_group;
+ else
+ tile_group = &instance->tile_group;
+
if (uh->disable_cdf_update == 0)
allow_update_cdf = 1;
@@ -1887,7 +1910,7 @@ static int vdec_av1_slice_init(struct mtk_vcodec_dec_ctx *ctx)
{
struct vdec_av1_slice_instance *instance;
struct vdec_av1_slice_init_vsi *vsi;
- int ret;
+ int ret, vsi_size = AV1_NON_EXT_VSI_SIZE;
instance = kzalloc(sizeof(*instance), GFP_KERNEL);
if (!instance)
@@ -1926,9 +1949,18 @@ static int vdec_av1_slice_init(struct mtk_vcodec_dec_ctx *ctx)
goto error_vsi;
}
- if (vsi->vsi_size != sizeof(struct vdec_av1_slice_vsi))
- mtk_vdec_err(ctx, "remote vsi size 0x%x mismatch! expected: 0x%zx\n",
- vsi->vsi_size, sizeof(struct vdec_av1_slice_vsi));
+ if (IS_VDEC_SUPPORT_EXT(ctx->dev->dec_capability)) {
+ vsi_size = sizeof(struct vdec_av1_slice_vsi);
+ vsi->iq_table_size = AV1_IQ_TABLE_SIZE;
+ vsi->cdf_table_size = AV1_CDF_SIZE;
+ }
+
+ if (vsi->vsi_size != vsi_size) {
+ mtk_vdec_err(ctx, "remote vsi size 0x%x mismatch! expected: 0x%x\n",
+ vsi->vsi_size, vsi_size);
+ ret = -EINVAL;
+ goto error_vsi;
+ }
instance->irq_enabled = 1;
instance->inneracing_mode = IS_VDEC_INNER_RACING(instance->ctx->dev->dec_capability);
--
2.46.0
prev parent reply other threads:[~2025-05-10 8:39 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-05-10 7:53 [PATCH 00/14] media: mediatek: vcodec: support video decoder in mt8196 Yunfei Dong
2025-05-10 7:53 ` [PATCH 01/14] dt-bindings: media: mediatek: vcodec: add decoder dt-bindings for mt8196 Yunfei Dong
2025-05-12 16:34 ` Conor Dooley
2025-05-10 7:53 ` [PATCH 02/14] media: mediatek: vcodec: add decoder compatible to support mt8196 Yunfei Dong
2025-05-10 7:53 ` [PATCH 03/14] media: mediatek: vcodec: add driver to support vcp Yunfei Dong
2025-05-10 7:53 ` [PATCH 04/14] media: mediatek: vcodec: add driver to support vcp encoder Yunfei Dong
2025-05-10 7:53 ` [PATCH 05/14] media: mediatek: vcodec: get different firmware ipi id Yunfei Dong
2025-05-10 7:53 ` [PATCH 06/14] media: mediatek: vcodec: get share memory address Yunfei Dong
2025-05-10 7:53 ` [PATCH 07/14] media: mediatek: vcodec: define MT8196 vcodec levels Yunfei Dong
2025-05-10 7:53 ` [PATCH 08/14] media: mediatek: vcodec: support vcp architecture Yunfei Dong
2025-05-10 7:53 ` [PATCH 09/14] media: mediatek: vcodec: support 36bit iova address Yunfei Dong
2025-05-10 7:53 ` [PATCH 10/14] media: mediatek: vcodec: clean xpc status Yunfei Dong
2025-05-10 7:53 ` [PATCH 11/14] media: mediatek: vcodec: add debug information Yunfei Dong
2025-05-10 7:53 ` [PATCH 12/14] media: mediatek: vcodec: send share memory address to vcp Yunfei Dong
2025-05-10 7:53 ` [PATCH 13/14] media: mediatek: decoder: fill av1 buffer size with picinfo Yunfei Dong
2025-05-10 7:53 ` Yunfei Dong [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20250510075357.11761-15-yunfei.dong@mediatek.com \
--to=yunfei.dong@mediatek.com \
--cc=Project_Global_Chrome_Upstream_Group@mediatek.com \
--cc=angelogioacchino.delregno@collabora.com \
--cc=benjamin.gaignard@collabora.com \
--cc=daniel.almeida@collabora.com \
--cc=daniel@ffwll.ch \
--cc=devicetree@vger.kernel.org \
--cc=frkoenig@chromium.org \
--cc=hsinyi@chromium.org \
--cc=hverkuil-cisco@xs4all.nl \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=nfraprado@collabora.com \
--cc=nhebert@chromium.org \
--cc=nicolas.dufresne@collabora.com \
--cc=sebastian.fricke@collabora.com \
--cc=stevecho@chromium.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox