[PATCH v2] arm64: dts: freescale: imx8mp-var-som: Add EQoS support with MaxLinear PHY

[Stefano Radaelli <stefano.radaelli21@gmail.com>]

Enable the EQoS Ethernet controller on the i.MX8MP VAR-SOM with the
integrated Maxlinear MXL86110 PHY. The PHY is connected to the EQOS
MDIO bus at address 4.

This patch adds:
- EQOS controller configuration with RGMII interface.
- Proper reset timings.
- PHY power supply regulators.
- RGMII pinmux configuration for all data, control and clock signals.
- LED configuration for link status indication via the LED subsystem
  under /sys/class/leds/, leveraging the support implemented in the.
  mxl86110 PHY driver (drivers/net/phy/mxl-86110.c).
  Two LEDs are defined to match the LED configuration on the Variscite
  VAR-SOM Carrier Boards:
    * LED@0: Yellow, netdev trigger.
    * LED@1: Green, netdev trigger.

The RGMII TX/RX delays are implemented in SOM via PCB passive
delays, so no software delay configuration is required.

Signed-off-by: Stefano Radaelli <stefano.radaelli21@gmail.com>
---
v2:
  - Removed 'eee' properties.

v1: https://lore.kernel.org/imx/20250609140643.26270-1-stefano.radaelli21@gmail.com/

 .../boot/dts/freescale/imx8mp-var-som.dtsi    | 86 +++++++++++++++++++
 1 file changed, 86 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mp-var-som.dtsi b/arch/arm64/boot/dts/freescale/imx8mp-var-som.dtsi
index b59da91fdd04..29f080904482 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp-var-som.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mp-var-som.dtsi
@@ -55,6 +55,24 @@ reg_usdhc2_vqmmc: regulator-usdhc2-vqmmc {
 		states = <3300000 0x0 1800000 0x1>;
 		vin-supply = <&ldo5>;
 	};
+
+	reg_phy_supply: regulator-phy-supply {
+		compatible = "regulator-fixed";
+		regulator-name = "phy-supply";
+		regulator-min-microvolt = <3300000>;
+		regulator-max-microvolt = <3300000>;
+		regulator-enable-ramp-delay = <20000>;
+		gpio = <&gpio2 20 GPIO_ACTIVE_HIGH>;
+		enable-active-high;
+		regulator-always-on;
+	};
+
+	reg_phy_vddio: regulator-phy-vddio {
+		compatible = "regulator-fixed";
+		regulator-name = "vddio-1v8";
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <1800000>;
+	};
 };
 
 &A53_0 {
@@ -73,6 +91,53 @@ &A53_3 {
 	cpu-supply = <&buck2>;
 };
 
+&eqos {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_eqos>;
+	/*
+	 * The required RGMII TX and RX 2ns delays are implemented directly
+	 * in hardware via passive delay elements on the SOM PCB.
+	 * No delay configuration is needed in software via PHY driver.
+	 */
+	phy-mode = "rgmii";
+	phy-handle = <&ethphy0>;
+	status = "okay";
+
+	mdio {
+		compatible = "snps,dwmac-mdio";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		ethphy0: ethernet-phy@4 {
+			compatible = "ethernet-phy-ieee802.3-c22";
+			reg = <4>;
+			reset-gpios = <&gpio1 10 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <100000>;
+			vddio-supply = <&reg_phy_vddio>;
+
+			leds {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				led@0 {
+					reg = <0>;
+					color = <LED_COLOR_ID_YELLOW>;
+					function = LED_FUNCTION_LAN;
+					linux,default-trigger = "netdev";
+				};
+
+				led@1 {
+					reg = <1>;
+					color = <LED_COLOR_ID_GREEN>;
+					function = LED_FUNCTION_LAN;
+					linux,default-trigger = "netdev";
+				};
+			};
+		};
+	};
+};
+
 &i2c1 {
 	clock-frequency = <400000>;
 	pinctrl-names = "default";
@@ -239,6 +304,27 @@ &wdog1 {
 
 &iomuxc {
 
+	pinctrl_eqos: eqosgrp {
+		fsl,pins = <
+			MX8MP_IOMUXC_ENET_MDC__ENET_QOS_MDC				0x2
+			MX8MP_IOMUXC_ENET_MDIO__ENET_QOS_MDIO				0x2
+			MX8MP_IOMUXC_ENET_RD0__ENET_QOS_RGMII_RD0			0x90
+			MX8MP_IOMUXC_ENET_RD1__ENET_QOS_RGMII_RD1			0x90
+			MX8MP_IOMUXC_ENET_RD2__ENET_QOS_RGMII_RD2			0x90
+			MX8MP_IOMUXC_ENET_RD3__ENET_QOS_RGMII_RD3			0x90
+			MX8MP_IOMUXC_ENET_RXC__CCM_ENET_QOS_CLOCK_GENERATE_RX_CLK	0x90
+			MX8MP_IOMUXC_ENET_RX_CTL__ENET_QOS_RGMII_RX_CTL			0x90
+			MX8MP_IOMUXC_ENET_TD0__ENET_QOS_RGMII_TD0			0x16
+			MX8MP_IOMUXC_ENET_TD1__ENET_QOS_RGMII_TD1			0x16
+			MX8MP_IOMUXC_ENET_TD2__ENET_QOS_RGMII_TD2			0x16
+			MX8MP_IOMUXC_ENET_TD3__ENET_QOS_RGMII_TD3			0x16
+			MX8MP_IOMUXC_ENET_TX_CTL__ENET_QOS_RGMII_TX_CTL			0x16
+			MX8MP_IOMUXC_ENET_TXC__CCM_ENET_QOS_CLOCK_GENERATE_TX_CLK	0x16
+			MX8MP_IOMUXC_SD2_WP__GPIO2_IO20					0x10
+			MX8MP_IOMUXC_GPIO1_IO10__GPIO1_IO10				0x150
+		>;
+	};
+
 	pinctrl_i2c1: i2c1grp {
 		fsl,pins = <
 			MX8MP_IOMUXC_SD1_DATA4__I2C1_SCL				0x400001c2

base-commit: e271ed52b344ac02d4581286961d0c40acc54c03
prerequisite-patch-id: 2335ebcc90360b008c840e7edf7e34a595880edf
-- 
2.43.0