Re: [PATCH v2 1/4] dt-bindings: mfd: rk806: allow to customize PMIC reset mode

[Krzysztof Kozlowski <krzk@kernel.org>]

On Thu, Jun 05, 2025 at 05:41:06PM GMT, Quentin Schulz wrote:
> +  rockchip,reset-mode:
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    enum: [0, 1, 2]
> +    description:
> +      Mode to use when a reset of the PMIC is triggered.
> +
> +      The reset can be triggered either programmatically, via one of
> +      the PWRCTRL pins (provided additional configuration) or
> +      asserting RESETB pin low.
> +
> +      The following modes are supported (see also
> +      include/dt-bindings/mfd/rockchip,rk8xx.h)
> +
> +      - 0 (RK806_RESTART) restart PMU,
> +      - 1 (RK806_RESET) reset all power off reset registers and force
> +        state to switch to ACTIVE mode,
> +      - 2 (RK806_RESET_NOTIFY) same as RK806_RESET and also pull
> +        RESETB pin down for 5ms,
> +
> +      For example, some hardware may require a full restart
> +      (RK806_RESTART mode) in order to function properly as regulators
> +      are shortly interrupted in this mode.
> +

This is fine, although now points to missing restart-handler schema and
maybe this should be once made common property. But that's just
digression, nothing needed here.

>    vcc1-supply:
>      description:
>        The input supply for dcdc-reg1.
> diff --git a/include/dt-bindings/mfd/rockchip,rk8xx.h b/include/dt-bindings/mfd/rockchip,rk8xx.h
> new file mode 100644
> index 0000000000000000000000000000000000000000..f058ed1ca661185f79738a358aa2d4f04539c590
> --- /dev/null
> +++ b/include/dt-bindings/mfd/rockchip,rk8xx.h
> @@ -0,0 +1,17 @@
> +/* SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause */
> +/*
> + * Device Tree defines for Rockchip RK8xx PMICs
> + *
> + * Copyright 2025 Cherry Embedded Solutions GmbH
> + *
> + * Author: Quentin Schulz <quentin.schulz@cherry.de>
> + */
> +
> +#ifndef _DT_BINDINGS_MFD_ROCKCHIP_RK8XX_H
> +#define _DT_BINDINGS_MFD_ROCKCHIP_RK8XX_H
> +
> +#define RK806_RESTART		0
> +#define RK806_RESET		1
> +#define RK806_RESET_NOTIFY	2

I do not see how this is a binding. Where do you use this in the driver
(to be a binding because otherwise you just add unused ABI)?

Best regards,
Krzysztof