[PATCH v3 2/4] clk: amlogic: Improve the issue of PLL lock failures

[Chuan Liu via B4 Relay <devnull+chuan.liu.amlogic.com@kernel.org>]

From: Chuan Liu <chuan.liu@amlogic.com>

Due to factors such as temperature and process variations, the
internal circuits of the PLL may require a longer time to reach a
steady state, which can result in occasional lock failures on some
SoCs under low-temperature conditions.

After enabling the PLL and releasing its reset, a 20 us delay is
added at each step to provide enough time for the internal PLL
circuit to stabilize, thus reducing the probability of PLL lock
failure.

Signed-off-by: Chuan Liu <chuan.liu@amlogic.com>
---
 drivers/clk/meson/clk-pll.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/drivers/clk/meson/clk-pll.c b/drivers/clk/meson/clk-pll.c
index 629f6af18ea1..70c8c7078046 100644
--- a/drivers/clk/meson/clk-pll.c
+++ b/drivers/clk/meson/clk-pll.c
@@ -369,10 +369,17 @@ static int meson_clk_pll_enable(struct clk_hw *hw)
 	/* Enable the pll */
 	meson_parm_write(clk->map, &pll->en, 1);
 
+	/* Wait for Bandgap and LDO to power up and stabilize */
+	udelay(20);
+
 	/* Take the pll out reset */
-	if (MESON_PARM_APPLICABLE(&pll->rst))
+	if (MESON_PARM_APPLICABLE(&pll->rst)) {
 		meson_parm_write(clk->map, &pll->rst, 0);
 
+		/* Wait for PLL loop stabilization */
+		udelay(20);
+	}
+
 	/*
 	 * Compared with the previous SoCs, self-adaption current module
 	 * is newly added for A1, keep the new power-on sequence to enable the

-- 
2.42.0