[PATCH v4 1/2] arm64: dts: ti: k3-j784s4-main.dtsi: Sort the nodes in appropriate order

[Abhash Kumar Jha <a-kumar2@ti.com>]

The device tree nodes should be ordered by unit addresses in ascending
order.

Correct the order by moving the dsp node at the end as it has a higher unit
address.

Signed-off-by: Abhash Kumar Jha <a-kumar2@ti.com>
---
 arch/arm64/boot/dts/ti/k3-j784s4-main.dtsi | 26 +++++++++++-----------
 1 file changed, 13 insertions(+), 13 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-main.dtsi b/arch/arm64/boot/dts/ti/k3-j784s4-main.dtsi
index 0160fe0da983..5b7830a3c097 100644
--- a/arch/arm64/boot/dts/ti/k3-j784s4-main.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j784s4-main.dtsi
@@ -6,19 +6,6 @@
  */
 
 &cbass_main {
-	c71_3: dsp@67800000 {
-		compatible = "ti,j721s2-c71-dsp";
-		reg = <0x00 0x67800000 0x00 0x00080000>,
-		      <0x00 0x67e00000 0x00 0x0000c000>;
-		reg-names = "l2sram", "l1dram";
-		resets = <&k3_reset 40 1>;
-		firmware-name = "j784s4-c71_3-fw";
-		ti,sci = <&sms>;
-		ti,sci-dev-id = <40>;
-		ti,sci-proc-ids = <0x33 0xff>;
-		status = "disabled";
-	};
-
 	pcie2_rc: pcie@2920000 {
 		compatible = "ti,j784s4-pcie-host";
 		reg = <0x00 0x02920000 0x00 0x1000>,
@@ -113,6 +100,19 @@ serdes2: serdes@5020000 {
 			status = "disabled";
 		};
 	};
+
+	c71_3: dsp@67800000 {
+		compatible = "ti,j721s2-c71-dsp";
+		reg = <0x00 0x67800000 0x00 0x00080000>,
+		      <0x00 0x67e00000 0x00 0x0000c000>;
+		reg-names = "l2sram", "l1dram";
+		resets = <&k3_reset 40 1>;
+		firmware-name = "j784s4-c71_3-fw";
+		ti,sci = <&sms>;
+		ti,sci-dev-id = <40>;
+		ti,sci-proc-ids = <0x33 0xff>;
+		status = "disabled";
+	};
 };
 
 &scm_conf {
-- 
2.34.1