[PATCH 1/2] arm64: dts: imx8qm-mek: switch Type-C connector power-role to dual

[Xu Yang <xu.yang_2@nxp.com>]

When attach to PC Type-A port, the USB device controller does not function
at all. Because it is configured as source-only and a Type-A port doesn't
support PD capability, a data role swap is impossible.

Actually, PTN5110THQ is configured for DFP/Source role only at POR, but
after POR it can operate as a DRP. By switching the power-role to dual,
the port can operate as a sink and enter device mode when attached to
Type-A port.

Since the board design uses EN_SRC to control the 5V VBUS path and EN_SNK
to control the 12V VBUS output, to avoid outputting a higher VBUS when in
sink role, we set the operation current limit to 0mA so that SW will not
control EN_SNK at all.

Signed-off-by: Xu Yang <xu.yang_2@nxp.com>
---
 arch/arm64/boot/dts/freescale/imx8qm-mek.dts | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8qm-mek.dts b/arch/arm64/boot/dts/freescale/imx8qm-mek.dts
index dadc136aec6e..8a832a0e105d 100644
--- a/arch/arm64/boot/dts/freescale/imx8qm-mek.dts
+++ b/arch/arm64/boot/dts/freescale/imx8qm-mek.dts
@@ -611,9 +611,13 @@ ptn5110: tcpc@51 {
 		usb_con1: connector {
 			compatible = "usb-c-connector";
 			label = "USB-C";
-			power-role = "source";
+			power-role = "dual";
 			data-role = "dual";
+			try-power-role = "sink";
 			source-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>;
+			sink-pdos = <PDO_FIXED(5000, 0, PDO_FIXED_USB_COMM)>;
+			op-sink-microwatt = <0>;
+			self-powered;
 
 			ports {
 				#address-cells = <1>;
-- 
2.34.1