[PATCH net v2 4/4] net: sparx5: configure serdes for 1000BASE-X in sparx5_port_init()

[Daniel Machon <daniel.machon@microchip.com>]

sparx5_port_init() only invokes sparx5_serdes_set() and the associated
shadow-device enable and low-speed device switch for SGMII and QSGMII.
On any port with a high-speed primary device (DEV5G/DEV10G/DEV25G)
configured for 1000BASE-X the serdes is therefore left uninitialized,
the DEV2G5 shadow is never enabled, and the port stays pointed at its
high-speed device rather than the DEV2G5. The PCS1G block looks
healthy in isolation, but no frames reach the link partner.

Add 1000BASE-X to the check so the same three steps run.

Note: the same issue might apply to 2500BASE-X, but that will,
eventually, be addressed in a separate commit.

Reported-by: Andrew Lunn <andrew@lunn.ch>
Fixes: 946e7fd5053a ("net: sparx5: add port module support")
Signed-off-by: Daniel Machon <daniel.machon@microchip.com>
---
 drivers/net/ethernet/microchip/sparx5/sparx5_port.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/microchip/sparx5/sparx5_port.c b/drivers/net/ethernet/microchip/sparx5/sparx5_port.c
index 04bc8fffaf96..62c49893de3c 100644
--- a/drivers/net/ethernet/microchip/sparx5/sparx5_port.c
+++ b/drivers/net/ethernet/microchip/sparx5/sparx5_port.c
@@ -1128,7 +1128,8 @@ int sparx5_port_init(struct sparx5 *sparx5,
 		DEV2G5_PCS1G_SD_CFG(port->portno));
 
 	if (conf->portmode == PHY_INTERFACE_MODE_QSGMII ||
-	    conf->portmode == PHY_INTERFACE_MODE_SGMII) {
+	    conf->portmode == PHY_INTERFACE_MODE_SGMII ||
+	    conf->portmode == PHY_INTERFACE_MODE_1000BASEX) {
 		err = sparx5_serdes_set(sparx5, port, conf);
 		if (err)
 			return err;

-- 
2.34.1