[PATCH v3 7/7] PCI: rzg3s-host: Use common pci_host_common_link_train_delay() helper

[Hans Zhang <18255117159@163.com>]

Replace the unconditional msleep(100) with the common helper
pci_host_common_link_train_delay(). The helper only waits when
max_link_speed > 2, as required by PCIe r6.0 sec 6.6.1.

This avoids unnecessary delay for Gen1/Gen2 links while retaining
the mandatory 100 ms for higher speeds.

Signed-off-by: Hans Zhang <18255117159@163.com>
---
 drivers/pci/controller/pcie-rzg3s-host.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/pci/controller/pcie-rzg3s-host.c b/drivers/pci/controller/pcie-rzg3s-host.c
index d86e7516dcc2..66f687304c1c 100644
--- a/drivers/pci/controller/pcie-rzg3s-host.c
+++ b/drivers/pci/controller/pcie-rzg3s-host.c
@@ -35,6 +35,7 @@
 #include <linux/slab.h>
 #include <linux/units.h>
 
+#include "pci-host-common.h"
 #include "../pci.h"
 
 /* AXI registers */
@@ -1663,7 +1664,7 @@ rzg3s_pcie_host_setup(struct rzg3s_pcie_host *host,
 	if (ret)
 		dev_info(dev, "Failed to set max link speed\n");
 
-	msleep(PCIE_RESET_CONFIG_WAIT_MS);
+	pci_host_common_link_train_delay(host->max_link_speed);
 
 	return 0;
 
-- 
2.34.1