From: Tejun Heo <tj@kernel.org>
To: void@manifault.com, arighi@nvidia.com, changwoo@igalia.com,
ast@kernel.org, andrii@kernel.org, daniel@iogearbox.net,
martin.lau@linux.dev, memxor@gmail.com
Cc: peterz@infradead.org, catalin.marinas@arm.com, will@kernel.org,
tglx@kernel.org, mingo@redhat.com, bp@alien8.de,
dave.hansen@linux.intel.com, akpm@linux-foundation.org,
david@kernel.org, rppt@kernel.org, emil@etsalapatis.com,
sched-ext@lists.linux.dev, bpf@vger.kernel.org, x86@kernel.org,
linux-arm-kernel@lists.infradead.org, linux-mm@kvack.org,
linux-kernel@vger.kernel.org, Tejun Heo <tj@kernel.org>
Subject: [PATCH bpf-next] bpf: Replace scratch PTE atomically when allocating arena pages
Date: Mon, 1 Jun 2026 08:37:28 -1000 [thread overview]
Message-ID: <20260601183728.1800490-1-tj@kernel.org> (raw)
apply_range_set_cb() maps the pages for a new arena allocation and returned
-EBUSY when the target PTE was already populated. Kernel-fault recovery
leaves the per-arena scratch page in unallocated arena PTEs, so a later
bpf_arena_alloc_pages() over such a page hits that -EBUSY, and every
subsequent allocation of it fails the same way. Allocation must install the
real page over scratch instead.
Overwriting the scratch PTE in place is a valid->valid change, which arm64
forbids without break-before-make. Route through an invalid entry instead:
ptep_try_set() fills only a none slot, so the PTE goes scratch->none->page.
On finding scratch, clear it and flush_tlb_before_set() before retrying. The
new flush_tlb_before_set() is a no-op except on arches like arm64 that need
the break-before-make TLB invalidate. The loop also copes with a concurrent
fault re-scratching the slot.
Arches without ptep_try_set() never install the scratch page, so keep the
must-be-empty check and set_pte_at() for them.
Fixes: dc11a4dba246 ("bpf: Recover arena kernel faults with scratch page")
Signed-off-by: Tejun Heo <tj@kernel.org>
Cc: Alexei Starovoitov <ast@kernel.org>
Cc: David Hildenbrand <david@kernel.org>
---
arch/arm64/include/asm/pgtable.h | 11 +++++++++++
include/linux/pgtable.h | 18 ++++++++++++++++++
kernel/bpf/arena.c | 38 +++++++++++++++++++++++++++++++++-----
3 files changed, 62 insertions(+), 5 deletions(-)
diff --git a/arch/arm64/include/asm/pgtable.h b/arch/arm64/include/asm/pgtable.h
index 984f050..3ce0f2a 100644
--- a/arch/arm64/include/asm/pgtable.h
+++ b/arch/arm64/include/asm/pgtable.h
@@ -1842,6 +1842,17 @@ static inline bool ptep_try_set(pte_t *ptep, pte_t new_pte)
}
#define ptep_try_set ptep_try_set
+/*
+ * arm64 mandates break-before-make: a cleared kernel PTE must have its TLB
+ * invalidated before a different page is installed in its place. The broadcast
+ * TLBI is an instruction, not an IPI, so this is safe with interrupts disabled.
+ */
+static inline void flush_tlb_before_set(unsigned long addr)
+{
+ flush_tlb_kernel_range(addr, addr + PAGE_SIZE);
+}
+#define flush_tlb_before_set flush_tlb_before_set
+
#define test_and_clear_young_ptes test_and_clear_young_ptes
static inline bool test_and_clear_young_ptes(struct vm_area_struct *vma,
unsigned long addr, pte_t *ptep, unsigned int nr)
diff --git a/include/linux/pgtable.h b/include/linux/pgtable.h
index b5739bb..4c6c408 100644
--- a/include/linux/pgtable.h
+++ b/include/linux/pgtable.h
@@ -1061,6 +1061,24 @@ static inline bool ptep_try_set(pte_t *ptep, pte_t new_pte)
}
#endif
+#ifndef flush_tlb_before_set
+/**
+ * flush_tlb_before_set - invalidate a kernel PTE's TLB before re-setting it
+ * @addr: kernel virtual address whose PTE was just cleared
+ *
+ * Some architectures (e.g. arm64) do not allow a live page-table entry to be
+ * repointed at a different page in one step. The old entry must first be made
+ * invalid and its translation flushed from every TLB, and only then may the new
+ * entry be written.
+ *
+ * This is only for the lockless atomic kernel-PTE installers (ptep_try_set()).
+ * It must be callable with interrupts disabled.
+ */
+static inline void flush_tlb_before_set(unsigned long addr)
+{
+}
+#endif
+
#ifndef wrprotect_ptes
/**
* wrprotect_ptes - Write-protect PTEs that map consecutive pages of the same
diff --git a/kernel/bpf/arena.c b/kernel/bpf/arena.c
index 1727503..b6ac5a9 100644
--- a/kernel/bpf/arena.c
+++ b/kernel/bpf/arena.c
@@ -142,6 +142,7 @@ static long compute_pgoff(struct bpf_arena *arena, long uaddr)
struct apply_range_data {
struct page **pages;
+ struct page *scratch_page;
int i;
};
@@ -154,19 +155,44 @@ static int apply_range_set_cb(pte_t *pte, unsigned long addr, void *data)
{
struct apply_range_data *d = data;
struct page *page;
+ pte_t pteval;
if (!data)
return 0;
- /* sanity check */
- if (unlikely(!pte_none(ptep_get(pte))))
- return -EBUSY;
page = d->pages[d->i];
/* paranoia, similar to vmap_pages_pte_range() */
if (WARN_ON_ONCE(!pfn_valid(page_to_pfn(page))))
return -EINVAL;
- set_pte_at(&init_mm, addr, pte, mk_pte(page, PAGE_KERNEL));
+ pteval = mk_pte(page, PAGE_KERNEL);
+#ifdef ptep_try_set
+ /*
+ * Kernel-fault recovery may have installed the scratch page here, and
+ * some architectures (arm64) prohibit valid->valid PTE transitions.
+ * Install atomically into a none slot. If scratch is present, clear it
+ * and flush_tlb_before_set() (break-before-make) before retrying.
+ */
+ while (!ptep_try_set(pte, pteval)) {
+ pte_t old = ptep_get(pte);
+
+ if (pte_none(old))
+ continue;
+ if (WARN_ON_ONCE(pte_page(old) != d->scratch_page))
+ return -EBUSY;
+ ptep_get_and_clear(&init_mm, addr, pte);
+ flush_tlb_before_set(addr);
+ }
+#else
+ /*
+ * Without ptep_try_set() there is no atomic installer, but such arches
+ * also do not wire up bpf_arena_handle_page_fault(), so no scratch page
+ * is ever installed and the slot is always none here.
+ */
+ if (unlikely(!pte_none(ptep_get(pte))))
+ return -EBUSY;
+ set_pte_at(&init_mm, addr, pte, pteval);
+#endif
d->i++;
return 0;
}
@@ -475,7 +501,8 @@ static vm_fault_t arena_vm_fault(struct vm_fault *vmf)
if (ret)
goto out_sigsegv_memcg;
- struct apply_range_data data = { .pages = &page, .i = 0 };
+ struct apply_range_data data = { .pages = &page, .i = 0,
+ .scratch_page = arena->scratch_page };
/* Account into memcg of the process that created bpf_arena */
ret = bpf_map_alloc_pages(map, NUMA_NO_NODE, 1, &page);
if (ret) {
@@ -665,6 +692,7 @@ static long arena_alloc_pages(struct bpf_arena *arena, long uaddr, long page_cnt
return 0;
}
data.pages = pages;
+ data.scratch_page = arena->scratch_page;
if (raw_res_spin_lock_irqsave(&arena->spinlock, flags))
goto out_free_pages;
next reply other threads:[~2026-06-01 18:37 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-06-01 18:37 Tejun Heo [this message]
2026-06-01 20:15 ` [PATCH bpf-next] bpf: Replace scratch PTE atomically when allocating arena pages bot+bpf-ci
2026-06-02 22:09 ` Tejun Heo
2026-06-02 22:29 ` Kumar Kartikeya Dwivedi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260601183728.1800490-1-tj@kernel.org \
--to=tj@kernel.org \
--cc=akpm@linux-foundation.org \
--cc=andrii@kernel.org \
--cc=arighi@nvidia.com \
--cc=ast@kernel.org \
--cc=bp@alien8.de \
--cc=bpf@vger.kernel.org \
--cc=catalin.marinas@arm.com \
--cc=changwoo@igalia.com \
--cc=daniel@iogearbox.net \
--cc=dave.hansen@linux.intel.com \
--cc=david@kernel.org \
--cc=emil@etsalapatis.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mm@kvack.org \
--cc=martin.lau@linux.dev \
--cc=memxor@gmail.com \
--cc=mingo@redhat.com \
--cc=peterz@infradead.org \
--cc=rppt@kernel.org \
--cc=sched-ext@lists.linux.dev \
--cc=tglx@kernel.org \
--cc=void@manifault.com \
--cc=will@kernel.org \
--cc=x86@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox