[PATCH v5 09/16] usb: hub: Use usb_hub_set_port_power() to control port power everywhere

[Chen-Yu Tsai <wenst@chromium.org>]

There are still some instances in the USB hub driver where port power is
directly controlled by toggling the USB_PORT_FEAT_POWER feature flag.

Switch these instances over to usb_hub_set_port_power() so that only one
unified function to do this exists. This makes adding external power
control with the power sequencing API easier and consistently applied.

Reviewed-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>
Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
Signed-off-by: Chen-Yu Tsai <wenst@chromium.org>
---
Changes since v2:
- New patch
---
 drivers/usb/core/hub.c | 9 +++------
 1 file changed, 3 insertions(+), 6 deletions(-)

diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
index 40cdb63b5333..47010090d3b6 100644
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -973,11 +973,8 @@ static void hub_power_on(struct usb_hub *hub, bool do_delay)
 		dev_dbg(hub->intfdev, "trying to enable port power on "
 				"non-switchable hub\n");
 	for (port1 = 1; port1 <= hub->hdev->maxchild; port1++)
-		if (test_bit(port1, hub->power_bits))
-			set_port_feature(hub->hdev, port1, USB_PORT_FEAT_POWER);
-		else
-			usb_clear_port_feature(hub->hdev, port1,
-						USB_PORT_FEAT_POWER);
+		usb_hub_set_port_power(hub->hdev, hub, port1,
+				       test_bit(port1, hub->power_bits));
 	if (do_delay)
 		msleep(hub_power_on_good_delay(hub));
 }
@@ -5434,7 +5431,7 @@ static void hub_port_connect(struct usb_hub *hub, int port1, u16 portstatus,
 		if (hub_is_port_power_switchable(hub)
 				&& !usb_port_is_power_on(port_dev, portstatus)
 				&& !port_dev->port_owner)
-			set_port_feature(hdev, port1, USB_PORT_FEAT_POWER);
+			usb_hub_set_port_power(hdev, hub, port1, true);
 
 		if (portstatus & USB_PORT_STAT_ENABLE)
 			goto done;
-- 
2.55.0.795.g602f6c329a-goog