[PATCH v3 3/3] net: xilinx: axienet: Propagate errors from platform_get_irq()

[phucduc.bui@gmail.com]

From: bui duc phuc <phucduc.bui@gmail.com>

platform_get_irq() returns a non-zero IRQ number on success and a
negative error number on failure. Therefore, 0 should not be treated
as an invalid IRQ number.

Propagate the original error code instead of overwriting it with
-ENOMEM.

Remove the redundant error message since platform_get_irq() already
reports errors when the IRQ lookup fails.

Signed-off-by: bui duc phuc <phucduc.bui@gmail.com>
---
 drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
index 50f88a38b6f6..d982ab6f8a4a 100644
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
@@ -2968,10 +2968,10 @@ static int axienet_probe(struct platform_device *pdev)
 			dev_err(&pdev->dev, "could not map DMA regs\n");
 			return PTR_ERR(lp->dma_regs);
 		}
-		if (lp->rx_irq <= 0 || lp->tx_irq <= 0) {
-			dev_err(&pdev->dev, "could not determine irqs\n");
-			return -ENOMEM;
-		}
+		if (lp->rx_irq < 0)
+			return lp->rx_irq;
+		if (lp->tx_irq < 0)
+			return lp->tx_irq;
 		if (lp->eth_irq < 0 && lp->eth_irq != -ENXIO)
 			return lp->eth_irq;
 
-- 
2.43.0