[PATCH v1 2/2] arm64: dts: freescale: imx93-imx91-toradex-osm-dev: Remove ETH_A PHY interrupt

[Francesco Dolcini <francesco@dolcini.it>]

From: Francesco Dolcini <francesco.dolcini@toradex.com>

The OSM Development Board is shared across OSM modules. The Ethernet PHY
interrupt connection to GPIO_A7 has been removed to resolve a boot strap
conflict on OSM iMX95.

Update the OSM iMX93 and iMX91 Device Trees accordingly. Remove the PHY
interrupt configuration to use polling, and move the GPIO_A7 pinctrl
configuration to the GPIO controller. The pin is now available in the
jumper area for general-purpose use.

Fixes: e8a8c86875f4 ("arm64: dts: freescale: Add Toradex OSM iMX93")
Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
---
 .../dts/freescale/imx93-imx91-toradex-osm-dev-common.dtsi   | 6 +-----
 1 file changed, 1 insertion(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx93-imx91-toradex-osm-dev-common.dtsi b/arch/arm64/boot/dts/freescale/imx93-imx91-toradex-osm-dev-common.dtsi
index 566671b32308..24b4bf579835 100644
--- a/arch/arm64/boot/dts/freescale/imx93-imx91-toradex-osm-dev-common.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx93-imx91-toradex-osm-dev-common.dtsi
@@ -93,7 +93,7 @@ &gpio2 {
 
 &gpio4 {
 	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_gpio_a6>;
+	pinctrl-0 = <&pinctrl_gpio_a6>, <&pinctrl_gpio_a7>;
 };
 
 /* OSM I2C_B */
@@ -262,10 +262,6 @@ &mdio {
 
 	ethphy_a: ethernet-phy@2 {
 		reg = <2>;
-		pinctrl-names = "default";
-		pinctrl-0 = <&pinctrl_gpio_a7>;
-		interrupt-parent = <&gpio4>;
-		interrupts = <15 IRQ_TYPE_LEVEL_LOW>;
 		ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
 		ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
 	};
-- 
2.47.3