[PATCH v2 4/6] mtd: rawnand: omap2: terminate DMA when prefetch cannot be enabled

[Samarth Narang <samarth.colleges@gmail.com>]

When omap_prefetch_enable() fails because the prefetch engine is busy,
omap_nand_dma_transfer() unmaps the buffer and falls back to a CPU copy
without terminating the previously issued DMA descriptor. The descriptor
may therefore continue accessing the unmapped buffer, while its callback
could also signal info->comp for a subsequent transfer.

Terminate the DMA channel with dmaengine_terminate_sync() before
unmapping the buffer, ensuring that the outstanding transfer has stopped
before the fallback path proceeds.

Fixes: 03d3a1df6da6 ("mtd: nand: omap2: Start dma request before enabling prefetch")
Assisted-by: LLM
Signed-off-by: Samarth Narang <samarth.colleges@gmail.com>
---
This issue was identified by a research static analyzer for DMA
lifecycle ordering and has not been validated on hardware.

 drivers/mtd/nand/raw/omap2.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/mtd/nand/raw/omap2.c b/drivers/mtd/nand/raw/omap2.c
index 552f36da7..b6bd4386c 100644
--- a/drivers/mtd/nand/raw/omap2.c
+++ b/drivers/mtd/nand/raw/omap2.c
@@ -417,9 +417,11 @@ static inline int omap_nand_dma_transfer(struct nand_chip *chip,
 	/*  configure and start prefetch transfer */
 	ret = omap_prefetch_enable(info->gpmc_cs,
 		PREFETCH_FIFOTHRESHOLD_MAX, 0x1, len, is_write, info);
-	if (ret)
+	if (ret) {
 		/* PFPW engine is busy, use cpu copy method */
+		dmaengine_terminate_sync(info->dma);
 		goto out_copy_unmap;
+	}
 
 	wait_for_completion(&info->comp);
 	tim = 0;
-- 
2.34.1