From mboxrd@z Thu Jan 1 00:00:00 1970 From: laurent.pinchart@ideasonboard.com (Laurent Pinchart) Date: Thu, 03 Oct 2013 11:56:40 +0200 Subject: [PATCH 01/05] ARM: shmobile: Sync KZM9D DTS with KZM9D reference DTS In-Reply-To: <20131003034947.GH28463@verge.net.au> References: <20131001103255.813.65710.sendpatchset@w520> <20131001103305.813.70296.sendpatchset@w520> <20131003034947.GH28463@verge.net.au> Message-ID: <2066391.GX4ZAHlWrz@avalon> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hi Simon, On Thursday 03 October 2013 12:49:48 Simon Horman wrote: > On Tue, Oct 01, 2013 at 07:33:05PM +0900, Magnus Damm wrote: > > From: Magnus Damm > > > > Copy the device nodes from KZM9D reference into the KZM9D > > device tree file. This will allow us to use a single DTS > > file regarless of kernel configuration. In case of legacy > > C board code the device nodes may or may not be used, but > > in the multiplatform case all the DT device nodes are used. > > > > Signed-off-by: Magnus Damm > > --- > > > > arch/arm/boot/dts/emev2-kzm9d.dts | 33 +++++++++++++++++++++++++++++++- > > 1 file changed, 32 insertions(+), 1 deletion(-) > > Thanks, I have queued this up in the dt3 branch. Splitting the series across two branches would result in bisection breakages I'm afraid. Would it be an issue to queue all patches to a single branch ? > It should make it into v3.13 but if not I'll rename the branch > dt after rebasing it on v3.13-rcX which will then be targeted at v3.14. -- Regards, Laurent Pinchart