From mboxrd@z Thu Jan 1 00:00:00 1970 From: timur@codeaurora.org (Timur Tabi) Date: Mon, 22 Jan 2018 14:03:44 -0600 Subject: [PATCH 3/3] pinctrl: qcom: Don't allow protected pins to be requested In-Reply-To: References: <20180110015848.11480-1-sboyd@codeaurora.org> <20180110015848.11480-4-sboyd@codeaurora.org> Message-ID: <243180ed-cbd2-b21d-f10f-e33ec0d3a34e@codeaurora.org> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 01/22/2018 07:55 AM, Timur Tabi wrote: > > Just FYI, I'm still going to have to parse "gpios" in my > pinctrl-qdf2xxx.c driver, even though you're also parsing it here. > That's because I need to make sure that the msm_pingroup array only > contains "approve" addresses in its ctl_reg fields. Also, my patch [PATCH 3/3] [v7] pinctrl: qcom: qdf2xxx: add support for new ACPI HID QCOM8002 Applies on top of your patches as-is. Also, what about [PATCH 1/3] [v2] Revert "gpio: set up initial state from .get_direction()" I think you still need this patch. -- Qualcomm Datacenter Technologies, Inc. as an affiliate of Qualcomm Technologies, Inc. Qualcomm Technologies, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project.