From mboxrd@z Thu Jan 1 00:00:00 1970 From: rogerq@ti.com (Roger Quadros) Date: Wed, 15 Feb 2017 12:10:22 +0200 Subject: [PATCH v13 06/12] usb: xhci: use bus->sysdev for DMA configuration In-Reply-To: <20170215085127.GA26227@b29397-desktop> References: <1486776443-2280-1-git-send-email-peter.chen@nxp.com> <1486776443-2280-7-git-send-email-peter.chen@nxp.com> <20170215013514.GA6579@b29397-desktop> <20170215085127.GA26227@b29397-desktop> Message-ID: <2a3d2d65-e531-aaca-d5a1-a71f818cec61@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org +Felipe, On 15/02/17 10:51, Peter Chen wrote: > On Wed, Feb 15, 2017 at 10:18:03AM +0200, Roger Quadros wrote: >> Peter, >> >> On 15/02/17 03:35, Peter Chen wrote: >>> On Tue, Feb 14, 2017 at 01:58:40PM +0100, Arnd Bergmann wrote: >>>> On Tue, Feb 14, 2017 at 1:26 PM, Roger Quadros wrote: >>>>> On 14/02/17 13:44, Arnd Bergmann wrote: >>>>>> On Tue, Feb 14, 2017 at 11:36 AM, Roger Quadros wrote: >>>> >>>>>>> Why are we using sysdev to read DT property? We should be using the >>>>>>> XHCI device (&pdev->dev) here, no? >>>>>> >>>>>> If I remember correctly, this is one of the cases where pdev does not >>>>>> have a device node attached to it because it was created by the driver >>>>>> of the parent device on the fly in case of dwc3. When you have a pure xhci >>>>>> device in DT, the two pointers are the same. >>>>> >>>>> From drivers/usb/dwc3/host.c >>>>> >>>>>> if (dwc->usb3_lpm_capable) { >>>>>> props[0].name = "usb3-lpm-capable"; >>>>>> ret = platform_device_add_properties(xhci, props); >>>>>> if (ret) { >>>>>> dev_err(dwc->dev, "failed to add properties to xHCI\n"); >>>>>> goto err1; >>>>>> } >>>>>> } >>>>> >>>>> So it is setting the usb3-lpm-capable property into the xhci platform device >>>>> and we should be reading the property from there. >>> >>> Why dwc3 needs another "snps,usb3_lpm_capable"? Why not using >>> "usb3-lpm-capable" at firmware directly? >> >> dwc3 is not setting "snps,usb3_lpm_capable" but "usb3-lpm-capable" for the >> xhci platform device. >> >> What did you mean by firmware? Did you mean something like BIOS? >> At least TI platforms don't use any firmware like BIOS. So dwc3 driver >> needs to create a platform device for xhci on the fly and set the DT properties. >> > > By readying code, the dwc3 calls dwc3_get_properties to set > dwc->usb3_lpm_capable, and at dwc3/host.c, it sets property > "usb3-lpm-capable" according to this flag, why not let common > code xhci-plat.c to get this property from sysdev which is DT > nodes for dwc3? > Felipe, any comments? -- cheers, -roger