From mboxrd@z Thu Jan 1 00:00:00 1970 From: d-gerlach@ti.com (Dave Gerlach) Date: Wed, 8 Feb 2017 08:45:55 -0600 Subject: [PATCH v5 2/4] Documentation: dt: add bindings for ti-cpufreq In-Reply-To: References: <20170203172929.23940-1-d-gerlach@ti.com> <20170203172929.23940-3-d-gerlach@ti.com> Message-ID: <2aba1159-9a48-329f-2a54-8079b32b06e2@ti.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On 02/08/2017 08:44 AM, Rob Herring wrote: > On Fri, Feb 3, 2017 at 11:29 AM, Dave Gerlach wrote: >> Add the device tree bindings document for the TI CPUFreq/OPP driver >> on AM33xx, AM43xx, DRA7xx, and AM57xx SoCs. The operating-points-v2 >> binding allows us to provide an opp-supported-hw property for each OPP >> to define when it is available. This driver is responsible for reading >> and parsing registers to determine which OPPs can be selectively enabled >> based on the specific SoC in use by matching against the opp-supported-hw >> data. >> >> Acked-by: Viresh Kumar >> Signed-off-by: Dave Gerlach >> --- > > [...] > >> +/* >> + * cpu0 has different OPPs depending on SoC revision and some on revisions >> + * 0x2 and 0x4 have eFuse bits that indicate if they are available or not >> + */ >> +cpu0_opp_table: opp_table { > > One step closer, but as I showed last time, use a '-', not '_'. I apologize I thought the comment was only about the 0, completely missed the underscore, you are correct, thanks. Regards, Dave > > Rob >