[PATCH v2 0/9] ARM: dts: support I2SE Duckbill devices

[stefan.wahren@i2se.com (Stefan Wahren)]

Am 22.01.2017 um 23:22 schrieb Michael Heimpold:
> This series updates/adds Device Tree support for I2SE's Duckbill
> device family.
>
> The Duckbill devices are small, pen-drive sized boards based on
> NXP's i.MX28 SoC. While the initial variants (Duckbill series) were
> equipped with a micro SD card slot only, the latest generation
> (Duckbill 2 series) have an additional internal eMMC onboard.
>
> Both device generations consists of four "family members":
>
> - Duckbill/Duckbill 2: generic board, intended to be used as
>   baseboard for custom designs and/or as development board
>
> - Duckbill EnOcean/Duckbill 2 EnOcean: come with an EnOcean
>   daugther board equipped with the popular TCM310 module
>
> - Duckbill 485/Duckbill 2 485: as the name implies, these
>   devices are intended to be used as Ethernet - RS485 converters
>
> - Duckbill SPI/Duckbill 2 SPI: not sold separately, but used
>   in I2SE's development kits for Green PHY HomePlug Powerline
>   communication
>
> Because the Duckbill series is EOL, this patch series only adds
> support for the latest Duckbill 2 series devices. However,
> support for the generic Duckbill board was already mainline,
> so update it to match vendor tree DT.

Acked-by: Stefan Wahren <stefan.wahren@i2se.com>

for patches 1,2,3,5