[PATCH] omap4: Fix ULPI PHY init for ES1.0 SDP (Re: 4430SDP boot failure)

[gadiyar@ti.com (Anand Gadiyar)]

Tony Lindgren wrote:
> Here's one more es1.0 fix after the recent USB changes.
>
> Regards,
>
> Tony
>
>
> Author: Tony Lindgren <tony@atomide.com>
> Date:   Tue Jan 11 15:03:03 2011 -0800
>
>     omap4: Fix ULPI PHY init for ES1.0 SDP
>
>     Commit 6aa85a5ae610106d89e50c7e1f760c56d12f9bc4 (omap4: 4430sdp:
>     enable the ehci port on 4430SDP) added code to enable EHCI
>     support on 4430sdp board.
>
>     Looks like the ULPI pin does not seem to be muxed properly on ES1.0
>     SDP and this causes the system to reboot when the ULPI PHY is
>     enabled.
>
>     Fix this by muxing the pin, this is the same setting for
>     both ES1.0 and ES2.0. Also add checking for gpio_request.
>
>     Cc: Keshava Munegowda <keshava_mgowda@ti.com
>     Signed-off-by: Tony Lindgren <tony@atomide.com>
>
> --- a/arch/arm/mach-omap2/board-4430sdp.c
> +++ b/arch/arm/mach-omap2/board-4430sdp.c
> @@ -554,6 +554,7 @@ static void __init omap_sfh7741prox_init(void)
>
>  #ifdef CONFIG_OMAP_MUX
>  static struct omap_board_mux board_mux[] __initdata = {
> +	OMAP4_MUX(USBB2_ULPITLL_CLK, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
>  	{ .reg_offset = OMAP_MUX_TERMINATOR },
>  };
>  #else
> @@ -576,11 +577,12 @@ static void __init omap_4430sdp_init(void)
>  	omap4_twl6030_hsmmc_init(mmc);
>
>  	/* Power on the ULPI PHY */
> -	if (gpio_is_valid(OMAP4SDP_MDM_PWR_EN_GPIO)) {
> -		/* FIXME: Assumes pad is already muxed for GPIO mode */
> -		gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY
VMDM_3V3");
> +	status = gpio_request(OMAP4SDP_MDM_PWR_EN_GPIO, "USBB1 PHY
VMDM_3V3");
> +	if (status)
> +		pr_err("%s: Could not get USBB1 PHY GPIO\n");

Tony,

This throws up a build warning as there's no parameter corresponding to
the %s. Showed up in linux-next as of today.

- Anand