From mboxrd@z Thu Jan  1 00:00:00 1970
From: jmkrzyszt@gmail.com (Janusz Krzysztofik)
Date: Wed, 08 Aug 2018 18:55:35 +0200
Subject: [RFC PATCH v2 07/12] mtd: rawnand: ams-delta: Set port direction
 once per transfer
In-Reply-To: <20180807205752.32cd3e53@bbrezillon>
References: <20180718235710.18242-1-jmkrzyszt@gmail.com>
 <20180806222918.12644-8-jmkrzyszt@gmail.com>
 <20180807205752.32cd3e53@bbrezillon>
Message-ID: <3260564.acbQT1CZaz@z50>
To: linux-arm-kernel@lists.infradead.org
List-Id: linux-arm-kernel.lists.infradead.org

Hi Boris,

On Tuesday, August 7, 2018 8:57:52 PM CEST Boris Brezillon wrote:
> On Tue,  7 Aug 2018 00:29:13 +0200
> Janusz Krzysztofik <jmkrzyszt@gmail.com> wrote:
> 
> > In its current shape, the driver sets data port direction before each
> > byte read/write operation, even during multi-byte transfers.  Since
> > performance of the driver is completely not acceptable on Amstrad Delta
> > after it has been converted to GPIO bitbang, try to improve things a
> > bit by setting the port direction only on first byte of each transfer.
> ...
> I'd suggest a slightly different approach where the data pins
> direction state is stored in the the priv struct and only changed when
> required. This way you just have to add a test in
> ams_delta_read/write_byte().

Good idea, I'm going to use it, thanks.

Once done, may I also move that one earlier in the series so that it can be 
applied while our discussion on GPIO bitmap changes still continues?

Thanks,
Janusz