[PATCH RFC V3 2/3] mxs: add driver for ocotp in i.MX23 and i.MX28

[arnd@arndb.de (Arnd Bergmann)]

On Saturday 18 October 2014 10:32:51 Stefan Wahren wrote:
> This patch brings readonly support for the On Chip OTP cells in the i.MX23
> and i.MX28 processor. The driver uses files (one for each cell) in sysfs
> as interface.
> 
> Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
> ---
>  drivers/misc/Kconfig     |   13 ++
>  drivers/misc/Makefile    |    1 +
>  drivers/misc/fsl_ocotp.c |  332 ++++++++++++++++++++++++++++++++++++++++++++++
>  3 files changed, 346 insertions(+)
>  create mode 100644 drivers/misc/fsl_ocotp.c
> 
> diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig
> index b841180..7455efa 100644
> --- a/drivers/misc/Kconfig
> +++ b/drivers/misc/Kconfig
> @@ -515,6 +515,19 @@ config VEXPRESS_SYSCFG
>           bus. System Configuration interface is one of the possible means
>           of generating transactions on this bus.
>  
> +config FSL_OCOTP
> +        tristate "Freescale MXS On-Chip OTP Memory Support"
> +        depends on ARCH_MXS && SYSFS
> +        help
> +          If you say Y here, you will get support for a readonly
> +         SysFS interface for the One Time Programmable memory pages that
> +         are stored on the Freescale i.MX23/i.MX28 processor.
> +
> +          To compile this driver as a module, choose M here: the module
> +          will be called fsl_ocotp.
> +
> +          If unsure, it is safe to say N.
> 

I think this needs to be an MTD driver, not a "misc" driver, and it
should use the proper MTD interfaces instead of introducing an
incompatible set of interfaces.

	Arnd