[PATCH v3 1/7] mfd: add pruss mfd driver.

[subhasish@mistralsolutions.com (Subhasish Ghosh)]

> On Wednesday 30 March 2011, Subhasish Ghosh wrote:
>>
>> >> +s32 pruss_disable(struct device *dev, u8 pruss_num)
>> >> +{
>> >> + struct da8xx_pruss *pruss = dev_get_drvdata(dev->parent);
>> >> + struct da8xx_prusscore_regs *h_pruss;
>> >> + struct pruss_map *pruss_mmap = (struct pruss_map *)pruss->ioaddr;
>> >> + u32 temp_reg;
>> >> + u32 delay_cnt;
>> >
>> > Can you explain the significance of pruss_num? As far as I
>> > can tell, you always pass constants in here, so it should
>> > be possible to determine the number from the device.
>>
>> SG - The number is not programmed in the device, I need something to 
>> decide
>> which PRU to disable or enable.
>
> I still don't understand. Please explain how the devices
> relate to the multiple PRUs in hardware.

There are two devices, CAN and UART, in our case we use the PRU as follows:
1. CAN-TX on PRU0, CAN-RX on PRU1
2. SUART-TX on PRU0, SUART-RX on PRU1
3. SUART-TXRX on PRU0, SUART-TXRX on PRU1