[PATCH 0/3] arm: dts: lpc32xx: update ssp / spi nodes

[arnd@arndb.de (Arnd Bergmann)]

On Monday 18 April 2016 07:45:00 Vladimir Zapolskiy wrote:
> Hi Arnd,
> 
> On 16.04.2016 22:34, Arnd Bergmann wrote:
> > On Thursday 14 April 2016 08:20:34 slemieux.tyco at gmail.com wrote:
> >> From: Sylvain Lemieux <slemieux@tycoint.com>
> >>
> >> This patchset change the following:
> >> 1) adds clock properties to spi peripheral devices,
> >>    clock ids are taken from dt-bindings/clock/lpc32xx-clock.h
> >>
> >> 2) disable, by default, the SSP0/SPI1 and SSP1/SPI2 shared pinout;
> >>    shared pin should be enable in board specific dts, as needed.
> >>
> >> 3) enable SSP0 used by PHY3250.
> >>
> >> Sylvain Lemieux (3):
> >>   arm: dts: lpc32xx: add clock properties to spi nodes
> >>   arm: dts: lpc32xx: disabled ssp0/spi1 & ssp1/spi2 by default
> >>   arm: dts: phy3250: enable ssp0
> >>
> >>  arch/arm/boot/dts/lpc32xx.dtsi | 16 ++++++++++++++
> >>  arch/arm/boot/dts/phy3250.dts  |  1 +
> >>  2 files changed, 15 insertions(+)
> >>
> >>
> > 
> > The patches look fine, but it's unclear what you want to happen with them
> > as long as the maintainer situation is not resolved. I've seen patches
> > from Vladimir and you recently, and none from Roland, so I think it would
> > be good if one or both of you could officially step up to be maintainers
> > and collect all patches to forward them to arm at kernel.org for inclusion.
> 
> for v4.5 and v4.6 I collected my own patches from LAKML after review,
> I started to do it for v4.7, but probably a bit later than desired.
> 
> Could you please remind me, when do ARM maintainers generally stop
> applying "for-next" pull requests?

There is no strict rule. We like to get patches as early as possible
though, and if you send a lot of stuff late we may ask for it to be
deferred until the following release.

If you have a lot of patches that go in early, it's more likely that
later follow-on patches get merged too.


	Arnd