From: arnd@arndb.de (Arnd Bergmann)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH 05/17] pci: host: pcie-dra7xx: add support for pcie-dra7xx controller
Date: Thu, 08 May 2014 11:16:16 +0200 [thread overview]
Message-ID: <4266819.iBi1FzBIBZ@wuerfel> (raw)
In-Reply-To: <000101cf6a9b$6c96c8d0$45c45a70$%han@samsung.com>
On Thursday 08 May 2014 17:56:38 Jingoo Han wrote:
> On Wednesday, May 07, 2014 6:26 PM, Arnd Bergmann wrote:
> > On Wednesday 07 May 2014 14:52:47 Kishon Vijay Abraham I wrote:
> > > On Tuesday 06 May 2014 10:05 PM, Jason Gunthorpe wrote:
> > > > On Tue, May 06, 2014 at 07:03:51PM +0530, Kishon Vijay Abraham I wrote:
> > > >> +Example:
> > > >> +pcie at 51000000 {
> > > >> + compatible = "ti,dra7xx-pcie";
> > > >> + reg = <0x51002000 0x14c>, <0x51000000 0x2000>;
> > > >> + reg-names = "ti_conf", "rc_dbics";
> > > >> + interrupts = <0 232 0x4>, <0 233 0x4>;
> > > >> + #address-cells = >;
> > > >> + #size-cells = <2>;
> > > >> + device_type = "pci";
> > > >> + ti,device_type = >;
> > > >> + ranges = <0x00000800 0 0x20001000 0x20001000 0 0x00002000 /* Configuration Space */
> > > >
> > > > Configuration space should not show up in the ranges, please don't
> > > > copy that mistake from other drivers, put it in reg.
> > >
> > > But then it needs pcie-designware.c to be modified and it will be breaking
> > > other platforms no?
> >
> > I think the pcie-designware driver should be changed to allow either way.
> > Ideally we would deprecate the existing method in a way that for new front-ends
> > it doesn't work, but the old front-ends can still deal with it but also work
> > if you put it into the reg property.
>
> (+cc Pratyush Anand, Thierry Reding)
>
> Hi Arnd,
>
> Thank you for your comment.
> Do you mean the case of Tegra PCIe as below?
>
> ./arch/arm/boot/dts/tegra20.dts
> pcie-controller at 80003000 {
> ...
> reg = <0x80003000 0x00000800 /* PADS registers */
> 0x80003800 0x00000200 /* AFI registers */
> 0x90000000 0x10000000>; /* configuration space */
> ...
> ranges = <0x82000000 0 0x80000000 0x80000000 0 0x00001000 /* port 0 registers */
> 0x82000000 0 0x80001000 0x80001000 0 0x00001000 /* port 1 registers */
> 0x81000000 0 0 0x82000000 0 0x00010000 /* downstream I/O */
> 0x82000000 0 0xa0000000 0xa0000000 0 0x08000000 /* non-prefetchable memory */
> 0xc2000000 0 0xa8000000 0xa8000000 0 0x18000000>; /* prefetchable memory */
> ...
>
> ./drivers/pci/host/pci-tegra.c
> /* request configuration space, but remap later, on demand */
> res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "cs");
> ...
> pcie->cs = devm_request_mem_region(pcie->dev, res->start,
> resource_size(res), res->name);
Yes, that is how the config space should be handled normally.
Arnd
next prev parent reply other threads:[~2014-05-08 9:16 UTC|newest]
Thread overview: 66+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-05-06 13:33 [PATCH 00/17] PCIe support for DRA7xx Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 01/17] phy: phy-omap-pipe3: Add support for PCIe PHY Kishon Vijay Abraham I
2014-05-14 12:57 ` Roger Quadros
2014-05-06 13:33 ` [PATCH 02/17] phy: omap-control: add external clock " Kishon Vijay Abraham I
2014-05-14 13:02 ` Roger Quadros
2014-05-06 13:33 ` [PATCH 03/17] phy: ti-pipe3: " Kishon Vijay Abraham I
2014-05-14 13:16 ` Roger Quadros
2014-05-14 15:19 ` Kishon Vijay Abraham I
2014-05-14 15:34 ` Nishanth Menon
2014-05-15 9:15 ` Kishon Vijay Abraham I
2014-05-15 9:25 ` Roger Quadros
2014-05-15 11:46 ` Nishanth Menon
2014-05-15 11:59 ` Kishon Vijay Abraham I
2014-05-15 12:12 ` Nishanth Menon
2014-05-15 12:18 ` Kishon Vijay Abraham I
2014-05-15 12:33 ` Nishanth Menon
2014-05-15 12:42 ` Kishon Vijay Abraham I
2014-05-27 6:11 ` Kishon Vijay Abraham I
2014-05-28 1:54 ` Mike Turquette
2014-05-28 15:52 ` Nishanth Menon
2014-05-06 13:33 ` [PATCH 04/17] phy: pipe3: insert delay to enumerate in GEN2 mode Kishon Vijay Abraham I
2014-05-14 13:20 ` Roger Quadros
2014-05-06 13:33 ` [PATCH 05/17] pci: host: pcie-dra7xx: add support for pcie-dra7xx controller Kishon Vijay Abraham I
2014-05-06 13:44 ` Marek Vasut
2014-05-07 8:21 ` Kishon Vijay Abraham I
2014-05-09 9:43 ` Pavel Machek
2014-05-06 13:54 ` Arnd Bergmann
2014-05-07 8:44 ` Kishon Vijay Abraham I
2014-05-07 9:30 ` Arnd Bergmann
2014-05-09 11:29 ` Kishon Vijay Abraham I
2014-05-06 16:35 ` Jason Gunthorpe
2014-05-07 9:22 ` Kishon Vijay Abraham I
2014-05-07 9:25 ` Arnd Bergmann
2014-05-08 8:56 ` Jingoo Han
2014-05-08 9:16 ` Arnd Bergmann [this message]
2014-05-06 13:33 ` [PATCH 06/17] pci: host: pcie-designware: Use *base-mask* for configuring the iATU Kishon Vijay Abraham I
2014-05-06 13:59 ` Arnd Bergmann
2014-05-08 9:05 ` Jingoo Han
2014-05-08 9:18 ` Arnd Bergmann
2014-05-09 11:50 ` Kishon Vijay Abraham I
2014-05-12 1:44 ` Jingoo Han
2014-05-13 12:31 ` Kishon Vijay Abraham I
2014-05-13 12:47 ` Arnd Bergmann
2014-05-13 13:26 ` Kishon Vijay Abraham I
2014-05-13 13:27 ` Arnd Bergmann
2014-05-13 13:34 ` Arnd Bergmann
2014-05-14 5:44 ` Kishon Vijay Abraham I
2014-05-14 12:45 ` Arnd Bergmann
2014-05-14 15:04 ` Kishon Vijay Abraham I
2014-05-16 9:00 ` Kishon Vijay Abraham I
2014-05-19 12:45 ` Arnd Bergmann
2014-05-06 13:33 ` [PATCH 07/17] ARM: dts: DRA7: Add divider table to optfclk_pciephy_div clock Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 08/17] ARM: dts: DRA7: Change the parent of apll_pcie_in_clk_mux to dpll_pcie_ref_m2ldo_ck Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 09/17] arm: dra7xx: Add hwmod data for pcie1 phy and pcie2 phy Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 10/17] arm: dra7xx: Add hwmod data for pcie1 and pcie2 subsystems Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 11/17] ARM: dts: dra7xx-clocks: Add missing 32khz clocks used for PHY Kishon Vijay Abraham I
2014-05-14 13:23 ` Roger Quadros
2014-05-14 15:19 ` Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 12/17] ARM: dts: dra7: Add dt data for PCIe PHY control module Kishon Vijay Abraham I
2014-05-06 13:33 ` [PATCH 13/17] ARM: dts: dra7: Add dt data for PCIe PHY Kishon Vijay Abraham I
2014-05-06 13:34 ` [PATCH 14/17] ARM: dts: dra7: Add dt data for PCIe controller Kishon Vijay Abraham I
2014-05-06 13:34 ` [PATCH 15/17] ARM: OMAP: Enable PCI for DRA7 Kishon Vijay Abraham I
2014-05-06 13:34 ` [TEMP PATCH 16/17] pci: host: pcie-dra7xx: use reset framework APIs to reset PCIe Kishon Vijay Abraham I
2014-05-06 13:41 ` Dan Murphy
2014-05-06 13:34 ` [TEMP PATCH 17/17] ARM: dts: dra7: Add *resets* property for PCIe dt node Kishon Vijay Abraham I
2014-05-06 13:40 ` Dan Murphy
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=4266819.iBi1FzBIBZ@wuerfel \
--to=arnd@arndb.de \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox