Re: [PATCH v5 4/6] arm64: Add initial support for Blaize BLZP1600 CB2

[Krzysztof Kozlowski <krzk@kernel.org>]

On 15/11/2024 15:58, Niko Pasaloukos wrote:
> Add support for the Blaize CB2 development board based on
> the BLZP1600 SoC. This consists of a Carrier-Board-2 and a
> System-on-Module.
> 
> Both BLZP1600 SoM and CB2 are available as products.
> CB2 (Pathfinder) has multiple peripherals like UART, I2C,
> SPI, GPIO, CSI (camera), DSI (display), USB-3.0 and Ethernet.
> 
> Enable support for the Cryptocell, UART and I2C which are
> already fully supported by the drivers.
> 
> The blaize-blzp1600.dtsi is the common part for the SoC,
> blaize-blzp1600-som.dtsi is the common part for the SoM and
> blaize-blzp1600-cb2.dts is the board specific file.
> 
> Co-developed-by: James Cowgill <james.cowgill@blaize.com>
> Signed-off-by: James Cowgill <james.cowgill@blaize.com>
> Co-developed-by: Matt Redfearn <matt.redfearn@blaize.com>
> Signed-off-by: Matt Redfearn <matt.redfearn@blaize.com>
> Co-developed-by: Neil Jones <neil.jones@blaize.com>
> Signed-off-by: Neil Jones <neil.jones@blaize.com>
> Signed-off-by: Nikolaos Pasaloukos <nikolaos.pasaloukos@blaize.com>

Subject prefix should be:
arm64: dts:
or

arm64: dts: blaize:

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>

Best regards,
Krzysztof