Re: [PATCH v3 0/2] ARM: dts: zynq: Add ALINX AX7Z020B development board

[Michal Simek <michal.simek@amd.com>]

On 11/12/26 20:32, Pufan Jin wrote:
> Add devicetree support for the ALINX AX7Z020B board, built around the
> ALINX AC7Z020 system on module with a Zynq-7000 (XC7Z020-2CLG400I) SoC.
> 
> Changes in v3:
> - Drop the vendor website Link: tags (Krzysztof Kozlowski).
> - Drop the empty bootargs property (Krzysztof Kozlowski).
> - Rename the USB PHY node from phy0 to phy, as there is only one USB PHY
>    on the board (Krzysztof Kozlowski).
> - Keep the explicit mdio node under gem0, as requested during the v1
>    review and reviewed by Andrew Lunn in v2.  dtc W=1 flags the parent
>    node's inherited #address-cells/#size-cells.  DT schema validation
>    reports the same Zynq-7000 diagnostics as zynq-zybo-z7.  The MDIO
>    layout was also verified on hardware.
> - Sort I2C child nodes by address and reorder status/reg properties.
> - Add Krzysztof's Acked-by to patch 1.
> 
> The "alinx" vendor prefix is already queued in linux-next as commit
> 1f06cd374a60 ("dt-bindings: vendor-prefixes: Add ALINX vendor prefix"),
> so it is not part of this series.
> 
> Tested on hardware before the DTS style reordering: SD boot, UART
> console, SD card, GbE (900+ Mbps and LED hardware offload), dual CAN,
> I2C, QSPI and XADC.
> 
> Pufan Jin (2):
>    dt-bindings: soc: xilinx: Add ALINX AX7Z020B board
>    ARM: dts: zynq: Add ALINX AX7Z020B development board
> 
>   .../bindings/soc/xilinx/xilinx.yaml           |   5 +
>   arch/arm/boot/dts/xilinx/Makefile             |   1 +
>   .../boot/dts/xilinx/zynq-alinx-ac7z020.dtsi   |  71 +++++++++
>   .../boot/dts/xilinx/zynq-alinx-ax7z020b.dts   | 146 ++++++++++++++++++
>   4 files changed, 223 insertions(+)
>   create mode 100644 arch/arm/boot/dts/xilinx/zynq-alinx-ac7z020.dtsi
>   create mode 100644 arch/arm/boot/dts/xilinx/zynq-alinx-ax7z020b.dts
Applied.
M