From mboxrd@z Thu Jan 1 00:00:00 1970 From: arnd@arndb.de (Arnd Bergmann) Date: Tue, 06 May 2014 15:59 +0200 Subject: [PATCH 06/17] pci: host: pcie-designware: Use *base-mask* for configuring the iATU In-Reply-To: <1399383244-14556-7-git-send-email-kishon@ti.com> References: <1399383244-14556-1-git-send-email-kishon@ti.com> <1399383244-14556-7-git-send-email-kishon@ti.com> Message-ID: <4764413.ZAEU5S5p0p@wuerfel> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org On Tuesday 06 May 2014 19:03:52 Kishon Vijay Abraham I wrote: > In DRA7, the cpu sees 32bit address, but the pcie controller can see only 28bit > address. So whenever the cpu issues a read/write request, the 4 most > significant bits are used by L3 to determine the target controller. > For example, the cpu reserves 0x2000_0000 - 0x2FFF_FFFF for PCIe controller but > the PCIe controller will see only (0x000_0000 - 0xFFF_FFF). So for programming > the outbound translation window the *base* should be programmed as 0x000_0000. > Whenever we try to write to say 0x2000_0000, it will be translated to whatever > we have programmed in the translation window with base as 0x000_0000. > > Cc: Bjorn Helgaas > Cc: Marek Vasut > Signed-off-by: Kishon Vijay Abraham I > Acked-by: Jingoo Han > Acked-by: Mohit Kumar Sorry, but NAK. We have a standard 'dma-ranges' property to handle this, so use it. See the x-gene PCIe driver patches for an example. Please also talk to Santosh about it, as he is implementing generic support for parsing dma-ranges in platform devices at the moment. I also suspect you will have to implement swiotlb support to make generic PCI devices work behind this bridge. Otherwise you end up with random physical addresses passed into DMA registers. Arnd