[PATCH 1/8 resend] dw_dmac: Remove compilation dependency from AVR32

[viresh.kumar@st.com (viresh kumar)]

On 03/05/2011 05:08 PM, Russell King - ARM Linux wrote:
> On Thu, Mar 03, 2011 at 09:49:09AM +0530, Shiraz Hashim wrote:
>> > On Thu, Mar 03, 2011 at 11:42:42AM +0800, Viresh KUMAR wrote:
>>> > > On 03/02/2011 10:16 PM, Koul, Vinod wrote:
>>>> > > > On Mon, 2011-02-28 at 16:11 +0530, Viresh Kumar wrote:
>> > 
>> > [...]
>> > 
>>>>> > > >>  drivers/dma/Kconfig |    1 -
>>>>> > > >>  1 files changed, 0 insertions(+), 1 deletions(-)
>>>>> > > >>
>>>>> > > >> diff --git a/drivers/dma/Kconfig b/drivers/dma/Kconfig
>>>>> > > >> index 1c28816..95c7db7 100644
>>>>> > > >> --- a/drivers/dma/Kconfig
>>>>> > > >> +++ b/drivers/dma/Kconfig
>>>>> > > >> @@ -82,7 +82,6 @@ config INTEL_IOP_ADMA
>>>>> > > >>  
>>>>> > > >>  config DW_DMAC
>>>>> > > >>  	tristate "Synopsys DesignWare AHB DMA support"
>>>>> > > >> -	depends on AVR32
>>>> > > > Shouldn't you be adding a corresponding depends on new arch? And since
>>>> > > > this supports old arch as well, it should say depends on both...
>>> > > 
>>> > > Why should this driver be dependent on ARM or AVR32? It can be present
>>> > > on any other arch too.. So i thought removing this dependency all together
>>> > > is better.
>> > 
>> > There could be a dependency on HAVE_CLK as it uses clock APIs.
> If it uses the clk APIs then it should already depend on HAVE_CLK.

It wasn't. But i have done that in my patchset.

-- 
viresh