[PATCH v2 1/2] OMAP2+: DMA: Workaround for invalid source position

[jarkko.nikula@bitmer.com (Jarkko Nikula)]

On 11/10/2011 02:46 PM, Jarkko Nikula wrote:
> On 11/07/2011 11:33 AM, Peter Ujfalusi wrote:
>> If the DMA source position has been asked before the
>> first actual data transfer has been done, the CSAC
>> register does not contain valid information.
>> We can identify this situation by checking the CDAC
>> register:
>> CDAC != 0 indicates that the DMA transfer on the channel has
>> been started already.
>> When CDAC == 0 we can not trust the CSAC value since it has
>> not been updated, and can contain random number.
>> Return the start address in case the DMA has not jet started.
>>
>> Note: The CDAC register has been initialized to 0 at dma_start
>> time.
>>
>> Signed-off-by: Peter Ujfalusi<peter.ujfalusi@ti.com>
>> ---
>> arch/arm/plat-omap/dma.c | 12 ++++++++++++
>> 1 files changed, 12 insertions(+), 0 deletions(-)
>>
>> diff --git a/arch/arm/plat-omap/dma.c b/arch/arm/plat-omap/dma.c
>> index c22217c..a9983b6 100644
>> --- a/arch/arm/plat-omap/dma.c
>> +++ b/arch/arm/plat-omap/dma.c
>> @@ -1034,6 +1034,18 @@ dma_addr_t omap_get_dma_src_pos(int lch)
>> if (IS_DMA_ERRATA(DMA_ERRATA_3_3)&& offset == 0)
>> offset = p->dma_read(CSAC, lch);
>>
>> + if (!cpu_is_omap15xx()) {
>> + /*
>> + * CDAC == 0 indicates that the DMA transfer on the channel has
>> + * not been started (no data has been transferred so far).
>> + * Return the programmed source start address in this case.
>> + */
>> + if (likely(p->dma_read(CDAC, lch)))
>> + offset = p->dma_read(CSAC, lch);
>> + else
>> + offset = p->dma_read(CSSA, lch);
>> + }
>> +
>
> I think this is enough:
>
> if (unlikely(p->dma_read(CDAC, lch) == 0))
> offset = p->dma_read(CSSA, lch);
>
> I suppose offset is ok for normal case as it is already read (twise) above.
>
Or actually my proposal could have a race if CDAC changes between CSAC 
read and CDAC read. In that case it's better to re-read CSAC as your 
patch does after CDAC test and give to both:

Reviewed-by: Jarkko Nikula <jarkko.nikula@bitmer.com>