[PATCH v7 0/5] AT91: replace broken TWI driver i2c-at91.c

[h.feurstein@gmail.com (Hubert Feurstein)]

Hi,

I've tested this driver on a 2.6.38 kernel with several i2c clients
(temp-sensor, audio-codec, touchscreen-controller, w1-bridge,
io-expanders) and works without problems. SoC: at91sam9g45

Because of the 2.6.38 kernel, I had to skip "[PATCH v7 2/5] Replace
clk_lookup.con_id with clk_lookup.dev_id entries for twi clk" and used
instead: at91_clock_associate("twi0_clk", &at91sam9g45_twi0_device.dev,
"twi_clk");

Best Regards
Hubert

On 2011-11-23 16:35, Nikolaus Voss wrote:
> The old driver has two main deficencies:
> i)  No repeated start (Sr) condiction is possible, this makes it unusable
>     e.g. for most SMBus transfers.
> ii) I/O was done with polling/busy waiting what caused over-/underruns
>     even at light system loads and clock speeds.
> 
> The new driver overcomes these deficencies and in addition allows for
> more than one TWI interface.
> 

Tested-by: Hubert Feurstein <h.feurstein@gmail.com>