From mboxrd@z Thu Jan 1 00:00:00 1970 From: sshtylyov@mvista.com (Sergei Shtylyov) Date: Wed, 21 Dec 2011 16:05:30 +0400 Subject: [PATCH v2] davinci: DA850 EVM: OHCI platform code In-Reply-To: References: <1324452002-8388-1-git-send-email-prakash.pm@ti.com> Message-ID: <4EF1CB8A.10309@mvista.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hello. On 21-12-2011 13:56, Nori, Sekhar wrote: > On Wed, Dec 21, 2011 at 12:50:02, Manjunathappa, Prakash wrote: >> From: Ajay Kumar Gupta >> On this board the OHCI port's power control and over-current signals from >> TPS2065 power switch are connected via GPIO2[4] and GPIO6[13] respectively, >> so we can implement the DA8xx OHCI glue layer's hooks for overriding the >> root hub port's power and over-current status bits. >> We also have to properly set up the clocking mode in the CFGCHIP2 register, >> so that internal 24 MHz reference clock is fed to the USB 2.0 (MUSB) PHY and >> its output is used to clock the USB 1.1 (OHCI) PHY... >> Signed-off-by: Ajay Kumar Gupta >> Signed-off-by: Manjunathappa, Prakash > This is the third copy of OHCI platform setup code which is almost > the same except for the GPIO numbers. Well, in my counting, it's only second, DA830 EVM being the first one. What's the third? > Can we attempt to consolidate > the GPIO case under drivers/usb/host/ohci-da8xx.c glue layer itself? > Of course, here should be a provision for non-GPIO based implementation > as well. > Sergei, any thoughts, comments? I designed the hub interface to be as abstract as I could, and now you're proposing to add GPIO to it? No, I have no clear idea how to keeep it abstract and add GPIO support at the same time. I would have been grateful to TI if I didn't have to invent this at all and they stop saving on OHCI pins. > Thanks, > Sekhar WBR, Sergei