Re: [PATCH v2 1/4] mmc: sdhci: fix timing selection for 1-bit bus width

[Adrian Hunter <adrian.hunter@intel.com>]

On 03/03/2026 12:50, ziniu.wang_1@nxp.com wrote:
> From: Luke Wang <ziniu.wang_1@nxp.com>
> 
> When 1-bit bus width is used with HS200/HS400 capabilities set,
> mmc_select_hs200() returns 0 without actually switching. This
> causes mmc_select_timing() to skip mmc_select_hs(), leaving eMMC
> in legacy mode (26MHz) instead of High Speed SDR (52MHz).
> 
> Per JEDEC eMMC spec section 5.3.2, 1-bit mode supports High Speed
> SDR. Drop incompatible HS200/HS400/UHS/DDR caps early so timing
> selection falls through to mmc_select_hs() correctly.
> 

Fixes: f2119df6b7646 ("mmc: sd: add support for signal voltage switch procedure")

> Signed-off-by: Luke Wang <ziniu.wang_1@nxp.com>
> ---
>  drivers/mmc/host/sdhci.c | 8 +++++++-
>  1 file changed, 7 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/mmc/host/sdhci.c b/drivers/mmc/host/sdhci.c
> index b1a3cd574c84..3e163f14a640 100644
> --- a/drivers/mmc/host/sdhci.c
> +++ b/drivers/mmc/host/sdhci.c
> @@ -4539,8 +4539,14 @@ int sdhci_setup_host(struct sdhci_host *host)
>  	 * their platform code before calling sdhci_add_host(), and we
>  	 * won't assume 8-bit width for hosts without that CAP.
>  	 */
> -	if (!(host->quirks & SDHCI_QUIRK_FORCE_1_BIT_DATA))
> +	if (host->quirks & SDHCI_QUIRK_FORCE_1_BIT_DATA) {
> +		host->caps1 &= ~(SDHCI_SUPPORT_SDR104 | SDHCI_SUPPORT_SDR50 |
> +				 SDHCI_SUPPORT_DDR50 | SDHCI_SUPPORT_HS400);

SDHCI_SUPPORT_HS400 is non-standard.  Hence the check for
SDHCI_QUIRK2_CAPS_BIT63_FOR_HS400 is needed:

		host->caps1 &= ~(SDHCI_SUPPORT_SDR104 | SDHCI_SUPPORT_SDR50 | SDHCI_SUPPORT_DDR50);
		if (host->quirks2 & SDHCI_QUIRK2_CAPS_BIT63_FOR_HS400)
			host->caps1 &= ~SDHCI_SUPPORT_HS400;

> +		mmc->caps2 &= ~(MMC_CAP2_HS200 | MMC_CAP2_HS400 | MMC_CAP2_HS400_ES);
> +		mmc->caps &= ~(MMC_CAP_DDR | MMC_CAP_UHS);
> +	} else {
>  		mmc->caps |= MMC_CAP_4_BIT_DATA;
> +	}
>  
>  	if (host->quirks2 & SDHCI_QUIRK2_HOST_NO_CMD23)
>  		mmc->caps &= ~MMC_CAP_CMD23;