From mboxrd@z Thu Jan 1 00:00:00 1970 From: gcembed@gmail.com (=?UTF-8?B?R2HDq3RhbiBDYXJsaWVy?=) Date: Mon, 20 Aug 2012 18:21:16 +0200 Subject: i.MX27 SLCDC driver In-Reply-To: References: <502DEDCD.9050303@gmail.com> Message-ID: <503263FC.8040901@gmail.com> To: linux-arm-kernel@lists.infradead.org List-Id: linux-arm-kernel.lists.infradead.org Hello On 08/20/2012 05:21 PM, Matt Sealey wrote: > On Fri, Aug 17, 2012 at 2:07 AM, Ga?tan Carlier wrote: >> Hello, >> I would like to write the driver for SmartLCD controller of i.MX27. This >> kind of interface needs a LCD with an embedded graphic controller partially >> controlled by GPIO. I want to link it with an OLED DD12832. >> >> How have I to write this driver : One driver for SLCDC and one driver for >> DD12832 ? How to link them together ? >> >> Maybe use similar philosophy than soc-camera ? > > Please use DRM if you can. That way your SLCDC controller is a "crtc" > and your OLED panel is a combination "encoder" and "connector". The > DRM subsystem isn't by far the best solution since it is designed > around PCI-class graphics cards and the split is intended for those > and not for more tightly-knit LCDC+display combinations, but it does > split things the way you're thinking and with a little extra code it > will do exactly what you want if a little less efficient than your > attached driver. > > I was sure Sascha had a driver for this already; > http://git.pengutronix.de/?p=imx/linux-2.6.git;a=commit;h=c333f47fa185edfd1c9d889fc8af040dd557b02c > - it should not be too hard to add your panel and the specific gpio > control as an encoder/connector. Maybe with a user this can actually > go upstream. > Thanks a lot for your advises. I will study this code. Regards, Ga?tan Carlier.